100 Mbit/s ethernet only - Goflex debian. [SOLVED.] Router restrict the speed!

Hi,

Update: Solution!!

The problem not related to Go flex net. It is a hidden
Power saving setting in Fritzbox - Network - LAN - .
When power saving switch offed then solved...



I have Bodhi 3.16.0-kirkwood-tld-2 and had old router.
Today I've got Gigabit ethernet router, but Goflex connect only 100 Mbit/s

Why not 1 Gbit/s speed of the ethernet? (while other device on the router other port shown as 1 Gbit/s.)

Should I set something in debian?


On my goflex dmesg:

root@pogo:~# dmesg | grep eth
[   13.017998] mv643xx_eth: MV-643xx 10/100/1000 ethernet driver version 1.4
[   14.096860] mv643xx_eth_port mv643xx_eth_port.0 eth0: port 0 with MAC address 00:10:75:26:6d:ec
[   39.060355] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   40.698337] mv643xx_eth_port mv643xx_eth_port.0 eth0: link up, 100 Mb/s, full duplex, flow control disabled
[   40.708176] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

Regards,
Robert



Edited 2 time(s). Last edit at 11/04/2014 03:06PM by robert1968@gmail.com.

Hey I had a simlar problems with my Pogo E02:
Sometimes it worked with full 1Gbit and most of the time only with 100mbit. Plugout-In ethernetcable helped, for a bit of time.
But after upgrading to 3.17-fdt these probs are gone.

Thank you very much.


I tried 10 times to eth out and in but never went to 1GBit/s ...

I Will upgrade to 3.17-fdt today. :)

Thanky anyway :)