Debian on D-Link DNS-325 - possible!

cryptodev isn't (yet) installed.
it doesn't seems to work with my (4.4.1) kernel (NSA325v2)

Edit:

the built binaries (make check) still make trouble
.



Edited 1 time(s). Last edit at 02/02/2016 09:25AM by pengu.

As I mentioned earlier, I have to use bodhis kernel because with all of my builds, only one HDD appears.
I didn't have that box anymore but it seems to have an RAID issue.
When creating a RAID0 it's still there after rebooting the box but a RAID 1 doesn't apeear after reboot.

Same rootfs, my kernel (4.4.6 and 4.4.18) on Iomega ix2-200) all good, the RAID appears.

[    9.785729] md: md0 stopped.
[    9.812239] md: bind<sdb>
[    9.843518] md: bind<sda>
[    9.877754] md: raid1 personality registered for level 1
[    9.903833] md/raid1:md0: active with 2 out of 2 mirrors
[    9.923973] created bitmap (15 pages) for device md0
[    9.967724] md0: bitmap initialized from disk: read 1 pages, set 0 of 29807 bits
[   10.032225] md0: detected capacity change from 0 to 2000264691712

As mentioned, I cannot use my builds because the second HDD is missing.

Edit
On ix2-200 it's working with all Kernels so I'm trying to get the logs from DNS-325 perhaps they will show why the RAID 1 doesn't come up after reboot.



Edited 1 time(s). Last edit at 09/17/2016 04:50AM by pengu.

@pengu,

I sent PM about another topic.

-bodhi
===========================
Forum Wiki
bodhi's corner (buy bodhi a beer)

ok it's back here again so I can have a closer look on it.
After doing a apt-get purge mdadm && apt-get install mdadm the RAID (0 or 1) is back again.
It also survives a reboot (as it should)

Nice!

-bodhi
===========================
Forum Wiki
bodhi's corner (buy bodhi a beer)