Debian on Lenovo ix2-dl June 05, 2017 06:19AM |
Registered: 8 years ago Posts: 295 |
| \/ | __ _ _ ____ _____| | | | |\/| |/ _` | '__\ \ / / _ \ | | | | | | (_| | | \ V / __/ | | |_| |_|\__,_|_| \_/ \___|_|_| _ _ ____ _ | | | | | __ ) ___ ___ | |_ | | | |___| _ \ / _ \ / _ \| __| | |_| |___| |_) | (_) | (_) | |_ \___/ |____/ \___/ \___/ \__| ** ix2-nand ** ** uboot_ver:0.0.8 ** ** MARVELL BOARD: DB-88F6282A-BP LE U-Boot 1.1.4 (Oct 28 2011 - 15:19:29) Marvell version: 3.6.1 - EMC U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CFB00 Soc: 88F6282 A1 CPU running @ 1600Mhz L2 running @ 533Mhz SysClock = 533Mhz , TClock = 200Mhz DRAM (DDR3) CAS Latency = 7 tRP = 7 tRAS = 20 tRCD=7 DRAM CS[0] base 0x00000000 size 256MB DRAM Total size 256MB 16bit width Addresses 8M - 0M are saved for the U-Boot usage. Mem malloc Initialization (8M - 7M): Done NAND:1024 MB Found ADT7473, program PWM1 ... OK Flash: 0 kB Marvell Serial ATA Adapter Integrated Sata device found CPU : Marvell Feroceon (Rev 1) Found kernel at 0x100000 Found initrd at 0x400000 Streaming disabled Write allocate disabled USB 0: host mode PEX 0: interface detected no Link. PEX 1: interface detected no Link. Net: egiga0 [PRIME] Hit any key to stop autoboot: 0
setenv load_initrd 'fatload usb 0:1 0x1100000 /uInitrd' setenv load_uimage 'fatload usb 0:1 0x800000 /uImage' setenv rootdelay 4 setenv rootfstype ext4 setenv usb_root 'LABEL=rootfs' setenv bootcmd 'run usb_boot' setenv usb_boot 'usb start; run load_uimage; run load_initrd; bootm 0x800000 0x1100000' setenv bootargs 'console=ttyS0,115200 root=LABEL=rootfs rootfstype=ext4 mtdparts=orion_nand:0x100000@0(uboot)ro,0x20000@0xA0000(uboot_env)'
(Re)start USB... USB: scanning bus for devices... 3 USB Device(s) found Waiting for storage device(s) to settle before scanning... 1 Storage Device(s) found reading /uImage ................................................................................................................................................. 3223931 bytes read reading /uInitrd ................................................................................................................................................. 6824496 bytes read ## Booting image at 00800000 ... Image Name: vmlinuz-4.9.30-kirkwood-rm-1 Created: 2017-06-05 10:33:02 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3223867 Bytes = 3.1 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK ## Loading Ramdisk Image at 01100000 ... Image Name: initrd.img-4.9.30-kirkwood-rm-1 Created: 2017-06-05 10:33:35 UTC Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 6824432 Bytes = 6.5 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Starting kernel ... [ 0.000000] Booting Linux on physical CPU 0x0 [ 0.000000] Linux version 4.9.30-kirkwood-rm-1 (root@iConnectTV) (gcc version 4.9.2 (Debian 4.9.2-10) ) #1 PREEMPT Sun Jun 4 01:56:52 CEST 207 [ 0.000000] CPU: Feroceon 88FR131 [56251311] revision 1 (ARMv5TE), cr=0005397f [ 0.000000] CPU: VIVT data cache, VIVT instruction cache [ 0.000000] OF: fdt:Machine model: Lenovo IX2-ng ...
sensors adt7473-i2c-0-2e Adapter: mv64xxx_i2c adapter in1: +1.10 V (min = +0.00 V, max = +2.99 V) +3.3V: +3.32 V (min = +2.96 V, max = +3.61 V) fan1: 793 RPM (min = 0 RPM) fan2: 0 RPM (min = 0 RPM) fan3: 0 RPM (min = 0 RPM) fan4: 0 RPM (min = 0 RPM) temp1: +49.2°C (low = -63.0°C, high = +191.0°C) (crit = +100.0°C, hyst = +96.0°C) Board Temp: +44.2°C (low = -63.0°C, high = +191.0°C) (crit = +100.0°C, hyst = +96.0°C) temp3: +41.5°C (low = -63.0°C, high = +191.0°C) (crit = +100.0°C, hyst = +96.0°C) kirkwood_thermal-virtual-0 Adapter: Virtual device temp1: +52.1°C
cat /proc/cpuinfo processor : 0 model name : Feroceon 88FR131 rev 1 (v5l) BogoMIPS : 1580.03 Features : swp half thumb fastmult edsp CPU implementer : 0x56 CPU architecture: 5TE CPU variant : 0x2 CPU part : 0x131 CPU revision : 1 Hardware : Marvell Kirkwood (Flattened Device Tree) Revision : 0000 Serial : 0000000000000000
free -m total used free shared buff/cache available Mem: 244 19 198 1 27 215 Swap: 255 9 246
... [ 140.124718] systemd-shutdown[1]: Sending SIGTERM to remaining processes... [ 140.143270] systemd-journald[205]: Received SIGTERM from PID 1 (systemd-shutdow). [ 140.166077] systemd-shutdown[1]: Sending SIGKILL to remaining processes... [ 140.183355] systemd-shutdown[1]: Unmounting file systems. [ 140.189888] systemd-shutdown[1]: Remounting '/' read-only with options 'data=ordered'. [ 140.223809] EXT4-fs (sda3): re-mounted. Opts: data=ordered [ 140.240940] systemd-shutdown[1]: Remounting '/' read-only with options 'data=ordered'. [ 140.249216] EXT4-fs (sda3): re-mounted. Opts: data=ordered [ 140.254837] systemd-shutdown[1]: All filesystems unmounted. [ 140.260483] systemd-shutdown[1]: Deactivating swaps. [ 140.265657] systemd-shutdown[1]: All swaps deactivated. [ 140.270977] systemd-shutdown[1]: Detaching loop devices. [ 140.280240] systemd-shutdown[1]: All loop devices detached. [ 140.384774] reboot: System halted
Re: Debian on Lenovo ix2-dl June 05, 2017 12:31PM |
Admin Registered: 13 years ago Posts: 18,564 |
Re: Debian on Lenovo ix2-dl June 05, 2017 03:20PM |
Registered: 8 years ago Posts: 295 |