Welcome! Log In Create A New Profile

Advanced

8192cu Changing wlan0 MAC adress

Posted by tux64 
8192cu Changing wlan0 MAC adress
September 30, 2012 07:03AM
Hi,

i try to modify mac adress of wifi device but nothing change
ifconfig wlan0 0.0.0.0 hw ether $MAC down
ifconfig wlan0 0.0.0.0 hw ether $MAC up
no error from output command and the mac address not changed.
tested on Android and rescue. same problem.

* or the module 8192cu need to load with param's ?
here full 8192cu param's.
parm:           rtw_ips_mode:The default IPS mode (int)
parm:           ifname:charp
parm:           rtw_initmac:charp
parm:           rtw_channel_plan:int
parm:           rtw_chip_version:int
parm:           rtw_rfintfs:int
parm:           rtw_lbkmode:int
parm:           rtw_network_mode:int
parm:           rtw_channel:int
parm:           rtw_mp_mode:int
parm:           rtw_wmm_enable:int
parm:           rtw_vrtl_carrier_sense:int
parm:           rtw_vcs_type:int
parm:           rtw_busy_thresh:int
parm:           rtw_ht_enable:int
parm:           rtw_cbw40_enable:int
parm:           rtw_ampdu_enable:int
parm:           rtw_rx_stbc:int
parm:           rtw_ampdu_amsdu:int
parm:           rtw_lowrate_two_xmit:int
parm:           rtw_rf_config:int
parm:           rtw_power_mgnt:int
parm:           rtw_low_power:int
parm:           rtw_wifi_spec:int
parm:           rtw_antdiv_cfg:int
parm:           rtw_enusbss:int
parm:           rtw_hwpdn_mode:int
parm:           rtw_hwpwrp_detect:int
parm:           rtw_max_roaming_times:The max roaming times to try (uint)
parm:           rtw_mc2u_disable:int

Thanks.
Re: 8192cu Changing wlan0 MAC adress
October 01, 2012 10:50AM
The easiest method is a udev rule to set it for you.
Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message: