__ __ _ _ | \/ | __ _ _ ____ _____| | | | |\/| |/ _` | '__\ \ / / _ \ | | | | | | (_| | | \ V / __/ | | |_| |_|\__,_|_| \_/ \___|_|_| _ _ ____ _ | | | | | __ ) ___ ___ | |_ | | | |___| _ \ / _ \ / _ \| __| | |_| |___| |_) | (_) | (_) | |_ \___/ |____/ \___/ \___/ \__| ** LOADER ** ** uboot_ver:v0.1.7 ** ** MARVELL BOARD: 88F6702A-TCC LE U-Boot 1.1.4 (Jun 25 2012 - 11:53:33) Marvell version: 3.6.0 U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CD5A0 Soc: 88F6702 A1 CPU running @ 1000Mhz L2 running @ 500Mhz SysClock = 400Mhz , TClock = 166Mhz DRAM (DDR2) CAS Latency = 6 tRP = 6 tRAS = 18 tRCD=6 DRAM CS[0] base 0x00000000 size 128MB DRAM Total size 128MB 16bit width Addresses 8M - 0M are saved for the U-Boot usage. Mem malloc Initialization (8M - 7M): Done [512kB@f8000000] Flash: 512 kB CPU : Marvell Feroceon (Rev 1) Streaming disabled Write allocate disabled USB 0: host mode PEX 0: interface detected no Link. Net: egiga0 [PRIME] Hit any key to stop autoboot: 0 Marvell>> printenv baudrate=115200 loads_echo=0 rootpath=/srv/ubuntu netmask=255.255.255.0 run_diag=yes console=console=ttyS0,115200 MALLOC_len=1 ethprime=egiga0 bootargs_root=root=/dev/ram0 rootfstype=cramfs init=/etc/rc.preroot initrd=0x800000,0x1000000 bootargs_end=:::DB88FXX81:eth0:none image_name=uImage standalone=fsload 0x2000000 $(image_name);setenv bootargs $(console) root=/dev/mtdblock0 rw ip=$(ipaddr):$(serverip)$(bootargs_end) $(mvPhoneConfig); bootm 0x2000000; ethmtu=1500 mvPhoneConfig=mv_phone_config=dev[0]:fxs,dev[1]:fxo mvNetConfig=mv_net_config=(00:11:88:0f:62:81,0:1:2:3),mtu=1500 usb0Mode=host netretry=no rcvrip=169.254.100.100 loadaddr=0x02000000 autoload=no image_multi=yes mfgmodel=TCC-C1 ethact=egiga0 ipaddr=192.168.1.2 bootcmd_u=usb reset; fatload usb 0:1 0x2000000 uImage; fatload usb 0:1 0x800000 rootfs_shrink.cramfs.canvio.preroot; setenv bootargs $(console) $(mtdparts) $(bootargs_root) $(bootargs_end); bootm 0x2000000; run bootcmd_n; mtdparts=mtdparts=spi_flash:0x0007E000@0x0(uboot),0x00001000@0x0007E000(param),0x00001000@0x0007F000(param2),0x80000@0x0(flash) bootcmd_n=tftp 0x2000000 $(tftp_remote_path)uImage; tftp 0x800000 $(tftp_remote_path)rootfs_shrink.cramfs.canvio.preroot; setenv bootargs $(console) $(mtdparts) $(bootargs_root) $(bootargs_end); bootm 0x2000000; uboot_ver=v0.1.7 mboot_ver= Marvell version: 3.6.0 serial_number=5564X01001G2440150BJ0A1 opid=Z12060274 ethaddr=E8:9D:87:F9:97:FF serialNo=447F70FJNWXX modelname=HDNB120XKEK1 testfile=100M ftp_user=autorunin ftp_passwd=123 remote_path=Ixxruninfiles/TCC-C1/bootimage/ ftp_serverip=192.168.32.4 tftp_serverip=192.168.32.4 serverip=192.168.32.4 tftp_remote_path=TCC-C1/bootimage/ preroot_ver=0.1.8 bootcmd=ide reset; ext2load ide 0:1 0x2000000 /boot/uImage; ext2load ide 0:1 0x800000 /boot/rootfs_shrink.cramfs.canvio.preroot; setenv bootargs $(console) $(mtdparts) $(bootargs_root) $(bootargs_end); bootm 0x2000000; run bootcmd_2; bootcmd_2=ext2load ide 1:1 0x2000000 /boot/uImage; ext2load ide 1:1 0x800000 /boot/rootfs_shrink.cramfs.canvio.preroot; setenv bootargs $(console) $(mtdparts) $(bootargs_root) $(bootargs_end); bootm 0x2000000; run bootcmd_u; runintime=14400 mfgtest_state=final_tested_ok fw_ver=0011.3060 stdin=serial stdout=serial stderr=serial mainlineLinux=no enaMonExt=no enaCpuStream=no enaWrAllo=no pexMode=RC disL2Cache=no setL2CacheWT=yes disL2Prefetch=yes enaICPref=yes enaDCPref=yes sata_dma_mode=yes netbsd_en=no vxworks_en=no bootdelay=3 disaMvPnp=no enaAutoRecovery=yes pcieTune=no Environment size: 2500/4091 bytes Marvell>>