I can/could get squeeze to boot fine with just the OS usb stick attached. I was attempting to make it a NAS and print server. It won't boot with the other ports occupied. Found this out by process of elimination. Now with all the reboots it won't boot to squeeze with JUST the OS usb stick attached. I can view netconsole just fine. Here's its output.
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 3 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
Loading file "/rescueme" from usb device 0:1 (usbda1)
** File not found /rescueme
reading /rescueme.txt
** Unable to read "/rescueme.txt" from usb 0:1 **
Creating 1 MTD partitions on "nand0":
0x000002500000-0x000008000000 : "mtd=3"
UBI: attaching mtd1 to ubi0
UBI: physical eraseblock size: 131072 bytes (128 KiB)
UBI: logical eraseblock size: 129024 bytes
UBI: smallest flash I/O unit: 2048
UBI: sub-page size: 512
UBI: VID header offset: 512 (aligned 512)
UBI: data offset: 2048
UBI: attached mtd1 to ubi0
UBI: MTD device name: "mtd=3"
UBI: MTD device size: 91 MiB
UBI: number of good PEBs: 728
UBI: number of bad PEBs: 0
UBI: max. allowed volumes: 128
UBI: wear-leveling threshold: 4096
UBI: number of internal volumes: 1
UBI: number of user volumes: 0
UBI: available PEBs: 717
UBI: total number of reserved PEBs: 11
UBI: number of PEBs reserved for bad PEB handling: 7
UBI: max/mean erase counter: 1/1
UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:rootfs", error -19
Error reading superblock on volume 'ubi:rootfs'!
Loading file "/boot/uImage" from usb device 0:1 (usbda1)
** ext2fs_devread() read error **
** File not found /boot/uImage
** Block device usb 1 not supported
** Block device usb 2 not supported
** Block device usb 3 not supported
Device NOT ready
Request Sense returned 06 28 00
** Can't read partition table on 0:0 **
** Bad partition 1 **
Device NOT ready
Request Sense returned 06 28 00
** Can't read partition table on 0:0 **
** Bad partition 1 **
Wrong Image Format for bootm command
ERROR: can't get kernel image!
stopping USB..
### JFFS2 loading 'uboot-original-mtd0.kwb' to 0x800000
Scanning JFFS2 FS: ......... done.
### JFFS2 load complete: 524288 bytes loaded to 0x800000
## Starting application at 0x00800200 ...
It looks like the usb stick partition is corrupt. I have attached it after booting into pogo and used "shutdown -rF now" to fsck but with no luck.
Any suggestions?