My goflex home can't boot after kirkwood 5.16.5 upgrade April 02, 2022 08:55AM |
Registered: 10 years ago Posts: 16 |
Reset IDE: Bus 0: OK Bus 1: not available Device 0: Model: ST31000524AS Firm: JC45 Ser#: 9VPC55YG Type: Hard Disk Supports 48-bit addressing Capacity: 953869.7 MB = 931.5 GB (1953525168 x 512) 10257 bytes read in 710 ms (13.7 KiB/s) <---- ext2load ide 0:1 0x1c00000 /boot/dts/kirkwood-goflexhome.dtb 5669000 bytes read in 5646 ms (980.5 KiB/s) <---- ext2load ide 0:1 0x800000 /boot/uImage 11782486 bytes read in 5392 ms (2.1 MiB/s) <---- ext2load ide 0:1 0x1100000 /boot/uInitrd ## Booting kernel from Legacy Image at 00800000 ... <---- bootm 0x800000 0x1100000 0x1c00000 Image Name: Linux-5.16.5-kirkwood-tld-1 Created: 2022-03-30 9:31:42 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 5668936 Bytes = 5.4 MiB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK ## Loading init Ramdisk from Legacy Image at 01100000 ... Image Name: initramfs-5.16.5-kirkwood-tld-1 Created: 2022-03-30 9:31:54 UTC Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 11782422 Bytes = 11.2 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ERROR: Did not find a cmdline Flattened Device Tree Could not find a valid device tree
Re: My goflex home can't boot after kirkwood 5.16.5 upgrade April 02, 2022 09:07AM |
Registered: 2 years ago Posts: 82 |
Re: My goflex home can't boot after kirkwood 5.16.5 upgrade April 02, 2022 03:51PM |
Admin Registered: 13 years ago Posts: 18,821 |
printenv bootPlease post the entire serial boot log (from the u-boot banner until when it stops booting).
Re: My goflex home can't boot after kirkwood 5.16.5 upgrade April 02, 2022 10:20PM |
Registered: 10 years ago Posts: 16 |
Re: My goflex home can't boot after kirkwood 5.16.5 upgrade April 02, 2022 10:31PM |
Admin Registered: 13 years ago Posts: 18,821 |