Welcome! Log In Create A New Profile

Advanced

Problem booting Kernel 4.4.38 Pogo V3 (Oxnas OX820) after upgraded

Posted by noregret 
Problem booting Kernel 4.4.38 Pogo V3 (Oxnas OX820) after upgraded
December 28, 2016 10:58PM
Kernel linux-4.4.38-oxnas-tld-5 will not boot. kernel 4.1 can boot up without any problem.

system is debian wheezy, already upgrade udev to 2.04

Loading, please wait...
[ 3.006220] systemd-udevd[94]: starting version 204
Begin: Loading essential drivers ... done.
Begin: Running /scripts/init-premount ... done.
Begin: Mounting root file system ... Begin: Running /scripts/local-top ... done.
Begin: Waiting for root file system ... done.
Gave up waiting for root device. Common problems:
- Boot args (cat /proc/cmdline)
- Check rootdelay= (did the system wait long enough?)
- Check root= (did the system wait for the right device?)
- Missing modules (cat /proc/modules; ls /dev)
ALERT! /dev/disk/by-label/rootfs does not exist. Dropping to a shell!
modprobe: module i8042 not found in modules.dep
modprobe: module uhci-hcd not found in modules.dep
modprobe: module ohci-hcd not found in modules.dep

BusyBox v1.20.2 (Debian 1:1.20.0-7) built-in shell (ash)
Enter 'help' for a list of built-in commands.

/bin/sh: can't access tty; job control turned off
(initramfs)



Edited 1 time(s). Last edit at 12/29/2016 12:42AM by bodhi.
Re: Problem booting Kernel 4.4.38 Pogo V3 (Oxnas OX820) after upgraded
December 29, 2016 12:46AM
This is a common problem with mounting rootfs.

Looks like you have serial console?

Go back to 4.4.38. Power up, interrupt serial console and

ver
printenv
boot

And post the entire serial console log here.

-bodhi
===========================
Wiki
latest Kirkwood kernel builds and rootfs
latest u-boot-kirkwood builds
latest Oxnas kernel builds and rootfs
latest u-boot-oxnas builds
latest MVEBU Armada kernel builds and rootfs
U-Boot & Kernel Booting process
bodhi's u-boot GitHub
bodhi's corner
Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message: