I know this might be wrong place to post this as most people over here use uboot...just hope someone can save my goflex net....
I followed official installation with ubit 0.6 and the installation failed with error, which i forgot.....sad
right now my goflex net can't start...green light keeps blinking...guess its bricked...
So i connect usb-serial cable and take a look...the console output is as below...seems like ubit didn't get installed correctly
Any comments would be aprreciated...i really wanna bring my goflex net back.......thanks a lot pals
btw where did the official installation page go? i can't find it anymore......
U-Boot 2010.09 (Feb 16 2011 - 18:42:02)
UBIT v0.6 by Jeff Doozan and Peter Carmichael
SoC: Kirkwood 88F6281_A0
DRAM: 128 MiB
NAND: 256 MiB
In: serial
Out: serial
Err: serial
Net: egiga0
88E1116 Initialized on egiga0
Creating 1 MTD partitions on "nand0":
0x000002500000-0x000010000000 : "mtd=3"
UBI: attaching mtd1 to ubi0
UBI: physical eraseblock size: 131072 bytes (128 KiB)
UBI: logical eraseblock size: 129024 bytes
UBI: smallest flash I/O unit: 2048
UBI: sub-page size: 512
UBI: VID header offset: 512 (aligned 512)
UBI: data offset: 2048
UBI: attached mtd1 to ubi0
UBI: MTD device name: "mtd=3"
UBI: MTD device size: 219 MiB
UBI: number of good PEBs: 1750
UBI: number of bad PEBs: 2
UBI: max. allowed volumes: 128
UBI: wear-leveling threshold: 4096
UBI: number of internal volumes: 1
UBI: number of user volumes: 0
UBI: available PEBs: 1729
UBI: total number of reserved PEBs: 21
UBI: number of PEBs reserved for bad PEB handling: 17
UBI: max/mean erase counter: 1/1
UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:silent", error -19
Error reading superblock on volume 'ubi:silent'!
UBIFS not mounted, use ubifs mount to mount volume first!
Using egiga0 device
ping failed; host 10.10.10.5 is not alive
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 1 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
Hit any key to stop autoboot: 0
UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:fast", error -19
Error reading superblock on volume 'ubi:fast'!
UBIFS not mounted, use ubifs mount to mount volume first!
** Block device usb 0 not supported
** Block device usb 0 not supported
** Invalid boot device **
** Invalid boot device **
** Block device usb 1 not supported
** Block device usb 1 not supported
** Invalid boot device **
** Invalid boot device **
** Block device usb 2 not supported
** Block device usb 2 not supported
** Invalid boot device **
** Invalid boot device **
** Block device usb 3 not supported
** Block device usb 3 not supported
** Invalid boot device **
** Invalid boot device **
Reset IDE: Bus 0: not available Bus 1: not available
** Bad partition 1 **
** Bad partition 1 **
No Powersaving mode 7F
Error (no IRQ) dev 0 blk 0: status 0x7f
** Can't read from device 0 **
** Unable to use ide 0:1 for fatload **
No Powersaving mode 7F
Error (no IRQ) dev 0 blk 0: status 0x7f
** Can't read from device 0 **
** Unable to use ide 0:1 for fatload **
** Bad partition 1 **
** Bad partition 1 **
No Powersaving mode 7F
Error (no IRQ) dev 1 blk 0: status 0x7f
** Can't read from device 1 **
** Unable to use ide 1:1 for fatload **
No Powersaving mode 7F
Error (no IRQ) dev 1 blk 0: status 0x7f
** Can't read from device 1 **
** Unable to use ide 1:1 for fatload **
UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:ramdisk", error -19
Error reading superblock on volume 'ubi:ramdisk'!
UBIFS not mounted, use ubifs mount to mount volume first!