Netgear Stora boot error with kernel 4.16.1-kirkwood-tld-1 June 05, 2018 04:53AM |
Registered: 5 years ago Posts: 2 |
[ 0.000000] INITRD: 0x00800000+0x00792000 overlaps in-use memory region - disabling initrd [ 0.020998] audit: initializing netlink subsys (disabled) [ 0.023432] [Firmware Info]: /ocp@f1000000/ethernet-controller@72000/ethernet0-port@0: local-mac-address is not set [ 0.029347] No ATAGs? [ 8.072222] [Firmware Warn]: /ocp@f1000000/mdio-bus@72004/ethernet-phy@8: Whitelisted compatible string. Please remove [ 10.081705] rtc-mv f1010300.rtc: internal RTC not ticking
Re: Netgear Stora 2hdd raid1 boot error June 05, 2018 02:20PM |
Admin Registered: 13 years ago Posts: 18,550 |
Re: Netgear Stora boot error with kernel 4.16.1-kirkwood-tld-1 June 06, 2018 07:16AM |
Registered: 5 years ago Posts: 2 |
__ __ _ _ | \/ | __ _ _ ____ _____| | | | |\/| |/ _` | '__\ \ / / _ \ | | | | | | (_| | | \ V / __/ | | |_| |_|\__,_|_| \_/ \___|_|_| _ _ ____ _ | | | | | __ ) ___ ___ | |_ | | | |___| _ \ / _ \ / _ \| __| | |_| |___| |_) | (_) | (_) | |_ \___/ |____/ \___/ \___/ \__| ** MARVELL BOARD: RD-88F6281A LE U-Boot 1.1.4 (Sep 4 2009 - 09:36:11) Marvell version: 3.4.14 U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CEE60 Soc: MV88F6281 Rev 3 (DDR2) CPU running @ 1000Mhz L2 running @ 333Mhz SysClock = 333Mhz , TClock = 200Mhz DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6 DRAM CS[0] base 0x00000000 size 64MB DRAM CS[1] base 0x04000000 size 64MB DRAM Total size 128MB 16bit width Flash: 0 kB Addresses 8M - 0M are saved for the U-Boot usage. Mem malloc Initialization (8M - 7M): Done NAND:256 MB CRC in Flash: a7c62151, Calculated CRC: a7c62151 CPU : Marvell Feroceon (Rev 1) Streaming disabled Write allocate disabled Module 0 is RGMII Module 1 is TDM USB 0: host mode PEX 0: interface detected no Link. Net: egiga0, egiga1 [PRIME] Hit any key to stop autoboot: 0 Reset IDE: Marvell Serial ATA Adapter Integrated Sata device found [0 0 0]: Enable DMA mode Device 0 @ 0 0: Model: Hitachi HUA723020ALA640 Firm: MK7OAA10 Ser#: MK0273YGHV8DLC Type: Hard Disk Supports 48-bit addressing Capacity: 1907729.0 MB = 1863.0 GB (-387938128 x 512) [0 1 0]: Enable DMA mode Device 1 @ 0 1: Model: Hitachi HDS722020ALA330 Firm: JKAOA20N Ser#: JK1121YAGAURZS Type: Hard Disk Supports 48-bit addressing Capacity: 1907729.0 MB = 1863.0 GB (-387938128 x 512) 3855275 bytes read 7948914 bytes read ## Booting image at 00200000 ... Image Name: Linux-4.16.1-stora-tld-1 Created: 2018-06-05 13:12:24 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3855211 Bytes = 3.7 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK ## Loading Ramdisk Image at 00800000 ... Image Name: initramfs-4.16.1-stora-tld-1 Created: 2018-06-05 13:12:29 UTC Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 7948850 Bytes = 7.6 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Starting kernel ... Uncompressing Linux... done, booting the kernel.
bootcmd_ide=ide reset; ext2load ide 0 0x200000 /boot/uImage; ext2load ide 0 0x800000 /boot/uInitrd bootcmd=setenv bootargs $(console) root=/dev/md0; run bootcmd_ide; bootm 0x200000 0x800000
Re: Netgear Stora boot error with kernel 4.16.1-kirkwood-tld-1 June 07, 2018 12:02AM |
Admin Registered: 13 years ago Posts: 18,550 |
bootcmd_ide=ide reset; ext2load ide 0 0x200000 /boot/uImage; ext2load ide 0 0x1100000 /boot/uInitrd bootcmd=setenv bootargs $(console) root=/dev/md0; run bootcmd_ide; bootm 0x200000 0x1100000
cat /sys/class/leds/status:blue:activity_led/trigger
echo none > /sys/class/leds/status:blue:activity_led/trigger
echo heartbeat > /sys/class/leds/status:blue:activity_led/trigger