Nas Server to install Debian

Hello
can you advise me to a Nas Server to install Debian in mail order
because I no longer find DockStar sale
Pogoplug and the less well because the fact that 800 Mhz processor rather than 1.2GHz?
thank you for your help

Pogo P21. Make sure it has UPC #850877002245.
Basically same as a Dockstar with twice the ram (256MB).
http://www.buy.com/prod/pogoplug-personal-cloud-media-sharing-solution-black/221688297.html



Edited 1 time(s). Last edit at 02/09/2012 04:58AM by laprjns.

^ Isn't it based on OXNAS whereas the Dockstar uses a Marvell processor etc.

varkey Wrote:
-------------------------------------------------------
> ^ Isn't it based on OXNAS whereas the Dockstar
> uses a Marvell processor etc.

No. If you get the one with UPC # 850877002245 then it's a Marvell kirkwood. I bought a Pogo-P21 from Buy.com for $25 expecting to get the OXNAS version, but even thought the label on the box said P21, the label on the bottom has Pogo E02 .

Ok thank you for lieb it is really not expensive
but can you tell me if the processor is powerful than the moin DockStar (1.2 ghz)
Pogoplug is better now in the ram (256MB) that the DockStar (128MB)
by the processor against my favorite one because it is compatible Marvell for Oscam
OXNAS that I do is not and I think it is the
on your link
http://www.buy.com/prod/pogoplug-personal-cloud-media-sharing-solution-black/221688297.html
what processor is it?
and any difference between OXNAS MARVELL?
thank you again for your help

Here is one with UPC # 850877002245:

http://www.jr.com/pogoplug/pe/PGG_POGOP21/

hank you but this is the same as the other link
can you give me the power of the processor?
it is less efficient than the DockStar?
thank you

It's the same spec as the Dockstar. But it has more RAM (256K). So yes it is more powerful than the Dockstar in that sense.

ArchLinux ARM forum has the specs for most of the plugs:
http://archlinuxarm.org/platforms



Edited 2 time(s). Last edit at 02/09/2012 04:55PM by bodhi.

It's supposed to be that only the E01 was the Marvell CPU with 256M memory. Any of the Pxx Bxx series had the PLX7820 CPU. I have been getting reports that some of the new Pxx and Bxx series are actually repackaged E02. So, at this point, it seems you cannot be sure which board you're going to get. The only one that is guaranteed to be the oxnas is the Pogoplug PRO and Pogoplug Video (recalled) because they need to have the PCIe bus which the Marvell board does not have.

do you have a website or I just buy a Pogoplug with an armel processuer
but sent to France
because the links above do not send to France
thank you

that the model is good for me?

http://cgi.ebay.fr/Pogoplug-Pro-Media-Network-Internet-External-Hard-Drive-Sharing-Device-Server-/170770664137?pt=LH_DefaultDomain_0&hash=item27c2b98ac9

or
http://cgi.ebay.fr/PogoPlug-POGO-P02-Media-Sharing-Device-Black-Pro-Connect-Any-External-Hard-Drive-/300659084096?pt=LH_DefaultDomain_2&hash=item4600ad8b40

versions:
POGO-P01 - Pro
POGO-P21 - V3
POGO-P25 - V3
are processors with ARMv6l?
thank you



Edited 1 time(s). Last edit at 02/11/2012 10:13AM by DJDavid.

yes they are ARM v6. And it is a nice and cheap device.

you have to know that :
1/ although install of linux is possible, it is not as flexible as on kirkwood based devices. long story short you are stuck with a 2.6.30 kernel with very few options
2/ the Video model got recalled because of the video chip overheating during heavy use and creating a fire hazard
3/ even if this is a dual core and v6 the oxnas is much less perfomant than the kirkwood: 2x700MHz oxnas gives you about 560 bogomips while 1x1GHz kirkwook gives about 900 Bogomips I do not have any figure for the 800 Mhz kirkwood
4/ you can boot from SATA,
5/ the newer pogoplug pro also carries (non bootable) USB 3.0 port and sd card

depending on your actual use case I'd rather go ( from cheapest to more expensive):
- pogo plug mobile and rig the sata port (Kirkwood 800MHz, 128 MB, wireless adapter).
- iomega Iconnect (kirkwood 1 GHz 256MB, wireless adapter, no sata)
- Go Flex Home (Kirkwood 1.2 GHz, 256MB, sata drive included no wireless built in)

Pogoplug P21 is available from Buy.com for $22.99 -- http://www.buy.com/prod/pogoplug-file-sharing-solution-black/221688297.html

Hello to all is thanks for your information
enfaite I changed radically I bought a DMP - eBox 3350MX x 86 Compact PC
much more dear but with map graphic and map its ect...
http://robosavvy.com/store/product_info.php/products_id/1704
but always with a consumption of 5 watt
as ca I just left turned my server 24/7
on the other hand I conné really this processor is 1 GHz
I would like to know if compared to the Dockstar 1. 2 GHz if it is even more efficient
I expected your opinion
Thank you

Pogoplug-p21 UPC code 850877002245 is not sufficient to identify a kirkwood marvel board.
http://forum.doozan.com/read.php?2,3202,10733,page=5#msg-10733