Pogoplug Pro

oddballhero Wrote:
> I actually have 2 and am using them as Print/Scan
> Servers for HP all-in-one Printers.

Did you disable the 'under-clocking'?

Mine has been very stable running at 266MHz

hopetindall Wrote:
-------------------------------------------------------
> oddballhero Wrote:
> > I actually have 2 and am using them as
> Print/Scan
> > Servers for HP all-in-one Printers.
>
> Did you disable the 'under-clocking'?
>
> Mine has been very stable running at 266MHz


Yes, but I didn't just flick off the resistor, I added a button and resistor to solder pads. The problem is once you undo the underclock, the length of time to telnet into redboot (http://www.nslu2-linux.org/wiki/HowTo/TelnetIntoRedBoot) is also decreased and since I've updated the firmware a few times, sometimes my non-volatile config settings gets blitzed. The faster clocking probably helped me when I was running asterisk on it but as a print/scanner server, it's fast enough either way. Since I run mine continuously, I try to make sure it's located in a place where it can dissipate heat well with proper ventilation and I also upgraded the power supply (if you have problems booting, this is a good thing to replace).

Are those last two posts really regarding the Pro/oxnas line?

Btw, oddballhero, we're working on:
- the 3.1 kernel, just need to get sata working, and full ethernet capability (and some odd usb issues i the hub..)
- u-boot - I have a patched up 1.1.2 that has IDE (SATA) & NAND boot/save capabilities
- I can provide anyone that might want it, the sata boot, stage1, u-boot, and procedures.

WarheadsSE Wrote:
-------------------------------------------------------
> Are those last two posts really regarding the
> Pro/oxnas line?

No, sorry about going off topic with the NSLU2.

>
> Btw, oddballhero, we're working on:
> - the 3.1 kernel, just need to get sata working,
> and full ethernet capability (and some odd usb
> issues i the hub..)

Believe me I've seen the OXNAS code, the usb portion is pretty ugly.

> - u-boot - I have a patched up 1.1.2 that has IDE
> (SATA) & NAND boot/save capabilities
> - I can provide anyone that might want it, the
> sata boot, stage1, u-boot, and procedures.

Great Job, WarheadsSE! I've seen your posts helping out user's on multiple distro's whether it be Arch, Debian, or even Optware. You're a true Linux guy. You, Jeff, and Martin help advance and promote the use of the small ARMs platforms, and all users benefit.

Sorry again about going off topic.

Status of 3.1 on the ox820 platform:
- SATA shell, not actually working yet.
- USB, sorted!
- Network: aligned to API, need to test offload settings.

"Magic SATA dust" - See my post here: http://archlinuxarm.org/forum/viewtopic.php?f=29&t=2146