HP T5325
please see below screen output mainly in relation to the S.O.C. statement
_ _ .____
| |_| | | _ \
| _ | | (_))
| |-| | | |
|_| |_| |_| ..
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** LOADER **
** BOARD: DB-88F6281A-BP LE
U-Boot 1.1.4 (Jan 8 2010 - 14:03:56) MIC version : 3.4.19-16
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CD4E0
Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 256MB
DRAM CS[1] base 0x10000000 size 256MB
DRAM Total size 512MB 16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
[1024kB@f8000000] Flash: 1 MB
CPU : Marvell Feroceon (Rev 1)
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: PCI Express Root Complex Interface
PEX interface detected Link X1
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
Reset IDE:
Marvell Serial ATA Adapter
Integrated Sata device found
[0 0 0]: Enable DMA mode (6)
Device 0 @ 0 0:
Model: SM22 Firm: I052 Ser#: (03)5526888-20080228
Type: Hard Disk
Capacity: 463.6 MB = 0.4 GB (949536 x 512)
2148560 bytes read
Checking Button Status: off
Checking GotoWOL Status: off
## Booting image at 00200000 ...
Image Name: Linux-2.6.22.18-1-armel
Created: 2009-10-08 13:56:48 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2148496 Bytes = 2 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
OK
Starting kernel ...
Uncompressing Linux.............................................................
............................................................................ done, booting the kernel
============================
Breaking stuff since 1994 :-)
============================