GoFlexNet not getting IP July 05, 2014 11:41PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 06, 2014 01:49PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 06, 2014 01:58PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 06, 2014 02:05PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 06, 2014 02:27PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 06, 2014 02:52PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 06, 2014 10:27PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 07, 2014 01:39AM |
Admin Registered: 13 years ago Posts: 18,560 |
This must be done as root user. Did you log into your Ubuntu as root?Quote
tar -zxvf ArchLinuxARM-kirkwood-latest.tar.gz -C
If you've installed Arch a couple years ago, then it was U-Bit, not a standard installation of U-Boot.Quote
I believe Uboot has to be installed once the goflex boots with the above and I can get SSH access to it.
Re: GoFlexNet not getting IP July 07, 2014 10:30AM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 07, 2014 02:18PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 07, 2014 11:30PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 08, 2014 04:20AM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 08, 2014 04:26AM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 08, 2014 08:26AM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 08, 2014 12:55PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 08, 2014 01:50PM |
Registered: 9 years ago Posts: 35 |
Your device could not be auto-detected. You must be using a device listed below to run this installer. What device are you using? Type the number of your device and press ENTER. 1 - Seagate Dockstar 2 - Seagate GoFlex Net 3 - Seagate GoFlex Home 4 - Pogoplug v1 5 - Pogoplug v2 - Pink 6 - Other 2 Selected Seagate GoFlex Net ./install_uboot_mtd0.sh: line 342: head: not found ./install_uboot_mtd0.sh: line 342: sed: not found # Installing uBoot ## Installing goflexnet Connecting to download.doozan.com (50.116.34.13:80) wget: server returned error: HTTP/1.1 404 Not Found Connecting to download.doozan.com (50.116.34.13:80) wget: server returned error: HTTP/1.1 404 Not Found ## uBoot could not be downloaded, or the MD5 does not match. ## Exiting. No changes were made to mtd0.
Re: GoFlexNet not getting IP July 08, 2014 04:15PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 08, 2014 09:59PM |
Registered: 9 years ago Posts: 35 |
ubit0-6:~# uname -a Linux ubit0-6 2.6.37-ubit-01715-g1e5cda0 #1 Mon Feb 7 01:35:47 GMT 2011 armv5tel GNU/Linux
ubit0-6:~# cat /proc/mtd dev: size erasesize name mtd0: 00100000 00020000 "u-boot" mtd1: 00400000 00020000 "uImage" mtd2: 02000000 00020000 "pogoplug" mtd3: 0db00000 00020000 "root"
ubit0-6:~# cat /proc/mtd dev: size erasesize name mtd0: 00100000 00020000 "u-boot" mtd1: 00400000 00020000 "uImage" mtd2: 02000000 00020000 "pogoplug" mtd3: 0db00000 00020000 "root" ubit0-6:~# cat /etc/fw_env.config # Configuration file for fw_(printenv/saveenv) utility. # Up to two entries are valid, in this case the redundant # environment sector is assumed present. # Notice, that the "Number of sectors" is ignored on NOR. # MTD device name Device offset Env. size Flash sector size Number of sectors /dev/mtd0 0x60000 0x20000 0x20000
ubit0-6:~# fw_printenv Too few good blocks within range
ubit0-6:~# which flash_erase -sh: which: not found
ubit0-6:~# which nandwrite -sh: which: not found
ubit0-6:~# dmesg -sh: dmesg: not found
wget http://jeff.doozan.com/debian/goflex/v0.6/uInitrd wget http://jeff.doozan.com/debian/goflex/v0.6/v2.6.37/boot.tar.gz mv boot oldboot tar -xvzf boot.tar.gz
#IMPORTANT # Once you have logged in to the UBIT prompt, unplug the USB stick to protect # the rescue system from being altered. The rescue system includes the OE firmware # to allow reverting to normal GoFlex Home configuration (not recommended). # WARNING DESTROYS CONTENT OF HARDDRIVE # If you think it best to start from scratch on the GoFlex disk: mke2fs -j /dev/sda1 on /dev/sda1 sh wget http://www.Arch Linux ARM.com/os/2010.12/Plugbox-Linux-2010.12-rootfs.tar.gz tar -xvzf Plugbox-Linux-2010.12-rootfs.tar.gz mv boot/uImage boot/olduImage wget http://jeff.doozan.com/debian/goflex/v0.6/v2.6.37/boot.tar.gz wget http://jeff.doozan.com/debian/goflex/v0.6/v2.6.37/modules.tar.gz tar -xvzf boot.tar.gz tar -xvzf modules.tar.gz # by the time you get here, you should just have a disk containing the Arch Linux ARM install # root filesystem and the UBIT kernel. This is a bootable combination with # the U-Boot you have installed. exit # exits from /dev/sda1 reboot; exit # hopefully reboots into Arch Linux ARM install
ubit0-6:~# fw_setenv serverip 192.168.1.38 Too few good blocks within range Error: environment not initialized
Re: GoFlexNet not getting IP July 09, 2014 03:00PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 10, 2014 02:49AM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 14, 2014 01:46PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 14, 2014 02:00PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 14, 2014 02:48PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 15, 2014 08:18PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 15, 2014 08:47PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 15, 2014 09:44PM |
Admin Registered: 13 years ago Posts: 18,560 |
Re: GoFlexNet not getting IP July 18, 2014 12:41PM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 29, 2014 04:07AM |
Registered: 9 years ago Posts: 35 |
Re: GoFlexNet not getting IP July 29, 2014 03:24PM |
Admin Registered: 13 years ago Posts: 18,560 |
U-Boot 2010.09 (Feb 16 2011 - 18:42:02) UBIT v0.6 by Jeff Doozan and Peter Carmichael
Image Name: Linux-3.14.4-1-ARCH Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3965072 Bytes = 3.8 MiB
Re: GoFlexNet not getting IP July 29, 2014 09:00PM |
Registered: 9 years ago Posts: 35 |