I also followed your instructions and successfully got the new 2023.04 U-Boot Kirkwood PogoV4 working without any issue. I upgraded my Pogoplug V4 A3 from the last 2017.07 U Boot. ` I have a 1TB hard drive that sits inside the top slot, but still boot off the usb 2.0 flash drive; I use the pogoplug for a home SAMBA server with just 2 Macs, 2 Windows and 1 chrombook. I needed to briefly lby dancyran - uBoot
oops- i was using a pogoplug v4; 5.11.4 kernel; SAMBA 4.9.5; with rootfs on a sdhd; 3 usb's ( 2 ext4 and 1 fat32) and 1TB hdd ext4. shares all authenticated -no guest. drives mounted and owner / permissions were set for my network.(the fat32 was mounted with group id).by dancyran - Debian
Bodhi -thanks for all your good advice, but: I disabled ipv6 as you mentioned above, -and lost my ability to access my shared disks (I am able to see my pogoplug v4 on the network, able to see the names of my disks, but unable to look at their contents). When I undo the ipv6 disablement , I resume all normal browsing and writing. (all other variable were left the same). Then I was able to repby dancyran - Debian
root@debian:/etc# cat resolv.conf domain home search home nameserver 192.168.1.1 I still think there's network weirdness -as I am not able to access (from my win7 laptop) one of the two winXP's (but other accesses well at this time). I was able to do this just before re-installing the cat5 wire. I have an old Actionteck MI424WR-gen3I router that otherwise seems to work wellby dancyran - Debian
Hi -does anyone have similar issue. I have a small home network with a Pogoplug v4 and two re-installed winXP's and and a win7 machine. The Pogoplug v4 is the a3 version, uboot is updated; I'm using the Debian--5.2.9 root disk with the update kernel 5.6.5. All seems to work well; I can ssh into it and it seems to work fine, but..... My windows network goes down; the shared disby dancyran - Debian
I hope this observation is helpful installing new kernel 5.5.1 on pogoplug v4 (A3 version) -I got "Bus Error" the forum had 3 search entries from cdlenfert and bodhi from feb 14, 2019 -hardware failure, but only the hard drive It worked the next try after a few things: 1. I 'woke up' my hard drive it is a segate st1000lm024 attached via the pogoplug usm/sata connectoby dancyran - Debian
Hi and thank you for the great work you've done. I've used it as a road map, but I realized a few problems near the end. I have a pogo-v4-a3-01 I've read your work and also Qui's (7/2014 blog.qnology.com) and Jack i.t. (2014 pogoplug4.blogspot.com) got your: linux-tools-installation-bodhi.tar.gz uboot.2016.05-tld-1.pogo_v4.bodhi.tar uboot.2016.05-tld-1.environmenby dancyran - uBoot