wwoooow incredible, worked you are the king Now how do I make it work after rebooting? Thank´s very very muchby kraftwerk - Debian
7245696 bytes read ## Booting image at 02000000 ... Image Name: Linux-4.12.1-kirkwood-tld-1 Created: 2017-09-08 16:42:15 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3836076 Bytes = 3.7 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... Bad Data CRCby kraftwerk - Debian
With commands setenv bootargs_linux 'console=ttyS0,115200 mtdparts=nand_mtd:0x100000(uboot),0x80000(uboot_env),0x80000(key_store),0x80000(info),0xA00000(etc),0xA00000(kernel_1),0x2FC0000(rootfs1),0xA00000(kernel_2),0x2FC0000(rootfs2) root=LABEL=rootfs loglevel=8 earlyprintk=serial' setenv bootcmd_linux 'setenv bootargs $(bootargs_linux); ide reset; ext2load ide 0:1 $(loadaddr)by kraftwerk - Debian
Sorry. it was my mistake I prepared everything as your tutorial, an ext3 partition with the rootfs. I'll leave it with an ext2 partition and an ext3 partition in order to execute your commands. Thank'sby kraftwerk - Debian
Reset IDE: Marvell Serial ATA Adapter Integrated Sata device found [0 0 0]: Enable DMA mode (5) Device 0 @ 0 0: Model: TOSHIBA MK2565GSXN Firm: GH101M Ser#: Z0SLD1G8B Type: Hard Disk Supports 48-bit addressing Capacity: 238475.1 MB = 232.8 GB (488397168 x 512) Failed to mount ext2 filesystem... ** Bad ext2 partby kraftwerk - Debian
Marvell>> printenv bootdelay=2 baudrate=115200 loads_echo=0 ipaddr=10.4.52.165 serverip=10.4.52.7 rootpath=/srv/ubuntu netmask=255.255.255.0 nandEcc=1bit MODEL_ID=AE03 PRODUCT_NAME=NSA-325v2 FEATURE_BIT=00 CONTRY_TYPE=FF VENDOR_NAME=MitraStar Technology Corp. run_diag=yes console=console=ttyS0,115200 mtdparts=nand_mtd:0xc0000@0(uboot)ro,0x7f00000@0x100000(root) ethprime=egby kraftwerk - Debian
In all possible ways it always freezes in bootin kernel. What else can I do? Thank´sby kraftwerk - Debian
I installed rootfs 4.4 and working, after, dist-upgrade to stretch and update initframs with kernel 4.12.1 with the same result. Booting kernel. Thank´sby kraftwerk - Debian
If I do it as the tutorial I can only ** Unable to read "/ uImage" from ide 0: 1 ** ** Unable to read "/ uInitrd" from ide 0: 1 ** ## Booting image at 02000000 ... Bad Magic Number Then I take the boot files and move it to the root of the hdd and it stops in booting kernel. I have also tried to make a boot partition and other partition rootfs with the same result.by kraftwerk - Debian
Hello, sorry for mi english. I installed the last rootfs in hdd in NSA325v2 with DTB in boot etc. When boot is freeze in: Starting kernel ... Uncompressing Linux... done, booting the kernel I can not pass from there Why? Thank´sby kraftwerk - Debian