Hi Bodhi, Finally I succeeded! Thanks a lot for your help! Netconsole is also working. Nice that thatÅ› possible at such a low level. I think i messed up the first time because i thought the B section was not obligatory. Also i did the backup of the current_envs and i got an "crc error using default something" But i was impatient. Its working now! . Now i can setup the rest ofby Snarky - uBoot
Hi Bodhi, Finally i had time to test uart booting. Unfortunately this doesnt work. kwboot-tool# ./kwboot -t -B 115200 /dev/ttyUSB0 -b uboot.2017.07-tld-1.pogo_v4.mtd0.kwb -p Sending boot message. Please reboot the target.../ Sending boot image... 0 % [.+.+xmodem: Protocol error without the -p flag ./kwboot -t -B 115200 /dev/ttyUSB0 -b uboot.2017.07-tld-1.pogo_v4.mtd0.by Snarky - uBoot
Hi Bodhi, I know it's almost unbrickable (unless you overheat something with a seemingly small yet giant soldering iron). I tried to activate ssh access via the website of pogoplug but the checkbox ssh access under security settings wasn't there anymore. But I managed to automatically startup the ssh daemon, dropbear. Makes life a bit easier. The first thing i had to do was remouby Snarky - uBoot
Hi Bodhi, Didnt read your post about the soft solder buttons. But i managed to solder some wires on and directly put some hotglue on it. So now im all setup for a new try! In the meanwhile ive found the pdf about u-boot. Im wondering if its not possible to let the stock uboot boot to usb. That would off course be a lot easier. But something is telling me its not that easy :-) I've setby Snarky - uBoot
Hi Bodhi, I lost contact via ssh and the serial cable got loose. While soldering i managed to brick it totally. Luckily I've got another fresh one lying around. I'll start allover again, now with more knowledge than zero. Cheers, Maartenby Snarky - uBoot
Hi Bodhi, I'm quite new to this and never used code tags. A very basic thing i guess but im not a programmer. (also i tried to change my username cause i didnt know what it meant till just a few moments ago). ls -lart /boot total 36264 drwxr-xr-x 2 root root 4096 Jul 15 15:14 dts -rw-r--r-- 1 root root 153501 Jul 15 20:21 config-4.12.1-kirkwood-tld-1 -rwxr-xr-x 1 root rootby Snarky - uBoot
Thanks for the quick reply! I understand now that the fw_ commands are in debian and not in the u_boot console. Here's the (quit long) output: U-Boot 2016.05-tld-1 (Jun 12 2016 - 13:41:47 -0700) Pogoplug V4 SoC: Kirkwood 88F6192_A1 DRAM: 128 MiB WARNING: Caches not enabled NAND: 128 MiB MMC: kwsdio: 0 In: serial Out: serial Err: serial Net: egiga0by Snarky - uBoot
Hi Bodi Finally i got my pogoplug v4 running again! I'm now trying to setup netconsole. The thing is only that the commands fw_setenv dont work. Its just setenv. I can boot in debian now and adjusted the /etc/fw_config but it seems its not read during booting. Im missing something (essential knowledge) but dont know what. Here is the output of my printenv. Pogov4> printenvby Snarky - uBoot