10.0 on guruplug missing boot sequence display
July 09, 2013 08:20AM
This is probably not strictly a Debian question but
I have compiled a 10.0 kernel for guruplug.
Runs ok except there is no display during the boot sequence when init steps through the run levels
Like the console is not being passed to init
Obviously a config parameter I failed to set
Config attached
Any pointers?
open | download - 10.0_config_20130709081804 (71.5 KB)

Your Email:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.