Forum List Message List New Topic
bramm
Looking desperately for ttl pinout and terminal settings for lenovo arm ix4-300d
January 31, 2023 07:22AM
Hi,

I'm looking desperately for a ttl pinout and terminal settings for lenovo arm ix4-300d. Does anyone have clue on how to get this working in a terminal? I've used 115200 8N1 but I get only a bit of gibberish.

Thanks

Bram
Reply Quote
1000001101000
Re: Looking desperately for ttl pinout and terminal settings for lenovo arm ix4-300d
January 31, 2023 08:37AM
Quote
https://github.com/benoitm974/ix4-300d/wiki
UART on connector CN9 (four pins, outer side of board) provides Vcc at pin 1 (marked). Connect Pin 2 to the RX pin of your serial adapter, Pin 3 is GND and Pin 4 is TX. Connection parameters are 115200/8N1. Vcc can be controlled by the adjacent JP1 (pin 1 marked); bridging 1/2 provides 3V3, bridging 2/3 provides 5V - but beware that this does NOT change the I/O voltage.
Reply Quote
Newer Topic Older Topic
Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message: