[SOLVED!] I goofed up my GoFlex NET September 15, 2013 04:39AM |
Registered: 10 years ago Posts: 8 |
Re: I goofed up my GoFlex NET September 15, 2013 01:54PM |
Registered: 10 years ago Posts: 8 |
Re: I goofed up my GoFlex NET September 15, 2013 03:25PM |
Registered: 10 years ago Posts: 8 |
cd /tmp wget http://jeff.doozan.com/debian/uboot/files/uboot/uboot.mtd0.goflexnet.original.kwb flash_erase /dev/mtd0 0 4 nandwrite /dev/mtd0 uboot.mtd0.goflexnet.original.kwb /sbin/rebootWhich later seemed obvious it would not work, but I read it here so thought I'd give it a try.
// Set Dockstar IP & netmask setenv ipaddr xxx.xxx.xxx.xxx setenv netmask xxx.xxx.xxx.xxx // Set TFTP server IP setenv serverip xxx.xxx.xxx.xxx // Confirm that you can get from Dockstar to TFTP server ping $(serverip) // Load uBoot to Dockstar RAM tftp 0x800000 uboot.mtd0.dockstar.original.kwb // Erase just enough of NAND to replace uBoot nand erase 0x0 0x80000 // Write uBoot from RAM to NAND nand write.e 0x800000 0x0 0x80000Which I read here
Re: I goofed up my GoFlex NET September 15, 2013 04:01PM |
Admin Registered: 13 years ago Posts: 18,629 |
Re: I goofed up my GoFlex NET September 15, 2013 09:45PM |
Registered: 10 years ago Posts: 8 |
Honestly, I'm scared of trying anything else at the moment, so just want to flash it to stock.Quote
bodhi
I'm not sure what are you trying to do? flashing back to stock, or get the GoFlex Net working with new uBoot?
I am unsure of when the kernel loads (See what I mean by low technical knowledge) so just sharing what I see before I press any key while the device is loading.Quote
bodhi
What is your serial console output? from booting up till before loading kernel.
Re: I goofed up my GoFlex NET September 15, 2013 10:37PM |
Registered: 10 years ago Posts: 8 |
Re: I goofed up my GoFlex NET September 15, 2013 10:39PM |
Admin Registered: 13 years ago Posts: 18,629 |
Re: I goofed up my GoFlex NET September 16, 2013 12:38AM |
Registered: 10 years ago Posts: 8 |
Re: I goofed up my GoFlex NET September 16, 2013 12:48AM |
Admin Registered: 13 years ago Posts: 18,629 |
Quote
[ 30.878507] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
...
No DHCPOFFERS received.
Re: I goofed up my GoFlex NET September 16, 2013 01:00AM |
Registered: 10 years ago Posts: 8 |
Re: I goofed up my GoFlex NET September 16, 2013 01:32AM |
Registered: 10 years ago Posts: 8 |
Re: I goofed up my GoFlex NET September 16, 2013 03:52AM |
Admin Registered: 13 years ago Posts: 18,629 |