meto Wrote:
-------------------------------------------------------
> Hello all,
>
> I found that I have an issue with my ZyXEL NSA325
> v1 - it is not booting after shutdown/restart. The
> power-off procedure runs smoothly - it
> restarts/shuts down normally, but when try to turn
> it on again it fails. The GREEN SYSTEM LED does
> not stop blinking. If I try to boot with no HDDs
> or with only one drive installed (no matter which
> drive and no matter which SATA slot) the device
> boots normally. The last time that happened I was
> forced to delete all the data and to make and
> install RAW partitions. After I've done it the
> system boots fine with both drives installed. Now
> I have too much data and I have no option to
> transfer it elsewhere. Please, give me some advice
> what can I do?
Are you running stock FW? This problem usually can be seen better and solved if you connect serial console.
-bodhi
===========================
Forum Wiki
bodhi's corner (buy bodhi a beer)