Semi-bricked Dockstar help needed: Have netconsole :( May 31, 2014 03:00PM |
Registered: 10 years ago Posts: 3 |
U-Boot 2014.01-tld-1 (Mar 17 2014 - 22:04:15) Seagate FreeAgent DockStar gcc (Debian 4.6.3-14) 4.6.3 GNU ld (GNU Binutils for Debian) 2.22 Hit any key to stop autoboot: 0 (Re)start USB... USB0: USB EHCI 1.00 scanning bus 0 for devices... 3 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found ** File not found /rescueme ** ** Unrecognized filesystem type ** UBI: attaching mtd1 to ubi0 UBI: physical eraseblock size: 131072 bytes (128 KiB) UBI: logical eraseblock size: 129024 bytes UBI: smallest flash I/O unit: 2048 UBI: sub-page size: 512 UBI: VID header offset: 512 (aligned 512) UBI: data offset: 2048 UBI: attached mtd1 to ubi0 UBI: MTD device name: "mtd=3" UBI: MTD device size: 219 MiB UBI: number of good PEBs: 1752 UBI: number of bad PEBs: 0 UBI: max. allowed volumes: 128 UBI: wear-leveling threshold: 4096 UBI: number of internal volumes: 1 UBI: number of user volumes: 0 UBI: available PEBs: 1731 UBI: total number of reserved PEBs: 21 UBI: number of PEBs reserved for bad PEB handling: 17 UBI: max/mean erase counter: 1/1 UBIFS error (pid 0): ubifs_get_sb: cannot open "rootfs", error -22 UBIFS error (pid 0): ubifs_mount: Error reading superblock on volume 'rootfs' er rno=-22! ubifsmount - mount UBIFS volume Usage: ubifsmount <volume-name> - mount 'volume-name' volume 1 bytes read in 557 ms (0 Bytes/s) Found bootable drive on usb 0:1 EHCI timed out on TD - token=0x1a008d80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 ** ext4fs_devread read error - block EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 EHCI timed out on TD - token=0x801f8c80 EHCI timed out on TD - token=0x80008d80 ** Can't read partition table on 0:0 ** ** Invalid partition 1 ** ## Booting kernel from Legacy Image at 00800000 ... Image Name: kernel 3.2.0-4-kirkwood Created: 2013-12-18 19:33:25 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1608432 Bytes = 1.5 MiB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... Bad Data CRC ERROR: can't get kernel image! stopping USB.. ### JFFS2 loading 'uboot-original-mtd0.kwb' to 0x800000 Scanning JFFS2 FS: ......... done. ### JFFS2 load complete: 524288 bytes loaded to 0x800000 ## Starting application at 0x00800200 ...
U-Boot 2014.01-tld-1 (Mar 17 2014 - 22:04:15) Seagate FreeAgent DockStar gcc (Debian 4.6.3-14) 4.6.3 GNU ld (GNU Binutils for Debian) 2.22 Hit any key to stop autoboot: 10 0 DockStar> printenv p r i n t e n v arcNumber=2097 baudrate=115200 bootcmd=usb start; run force_rescue_bootcmd; run ubifs_bootcmd; run usb_bootcmd; usb stop; run rescue_bootcmd; run pogo_bootcmd; reset bootdelay=10 console=ttyS0,115200 ethact=egiga0 ethaddr=00:10:75:1A:95:A2 force_rescue=0 force_rescue_bootcmd=if test $force_rescue -eq 1 || ext2load usb 0:1 0x1700000 / rescueme 1 || fatload usb 0:1 0x1700000 /rescueme.txt 1; then run rescue_bootcmd ; fi if_netconsole=ping $serverip ipaddr=10.0.0.9 led_error=orange blinking led_exit=green off led_init=green blinking mainlineLinux=yes mtdids=nand0=orion_nand mtdparts=mtdparts=orion_nand:1M(u-boot),4M(uImage),32M(rootfs),-(data) ncip=10.0.0.174 partition=nand0,2 pogo_bootcmd=if fsload uboot-original-mtd0.kwb; then go 0x800200; fi preboot=run if_netconsole start_netconsole rescue_bootcmd=if test $rescue_installed -eq 1; then run rescue_set_bootargs; na nd read.e 0x800000 0x100000 0x400000; bootm 0x800000; else run pogo_bootcmd; fi rescue_installed=0 rescue_set_bootargs=setenv bootargs console=$console ubi.mtd=2 root=ubi0:rootfs ro rootfstype=ubifs $mtdparts $rescue_custom_params serverip=10.0.0.174 start_netconsole=setenv ncip $serverip; setenv bootdelay 10; setenv stdin nc; se tenv stdout nc; setenv stderr nc; version; stderr=nc stdin=nc stdout=nc ubifs_bootcmd=run ubifs_set_bootargs; if ubi part data && ubifsmount rootfs && u bifsload 0x800000 /boot/uImage && ubifsload 0x1100000 /boot/uInitrd; then bootm 0x800000 0x1100000; fi ubifs_mtd=3 ubifs_set_bootargs=setenv bootargs console=$console ubi.mtd=$ubifs_mtd root=ubi0 :rootfs rootfstype=ubifs $mtdparts $ubifs_custom_params usb_boot=mw 0x800000 0 1; ext2load usb $usb_device 0x800000 /boot/uImage; if ext 2load usb $usb_device 0x1100000 /boot/uInitrd; then bootm 0x800000 0x1100000; el se bootm 0x800000; fi usb_bootcmd=run usb_init; run usb_set_bootargs; run usb_boot usb_device=0:1 usb_init=run usb_scan usb_root=/dev/sda1 usb_rootdelay=10 usb_rootfstype=ext3 usb_scan=usb_scan_done=0;for scan in $usb_scan_list; do run usb_scan_$scan; if t est $usb_scan_done -eq 0 && ext2load usb $usb 0x800000 /boot/uImage 1; then usb_ scan_done=1; echo "Found bootable drive on usb $usb"; setenv usb_device $usb; se tenv usb_root /dev/$dev; fi; done usb_scan_1=usb=0:1 dev=sda1 usb_scan_2=usb=1:1 dev=sdb1 usb_scan_3=usb=2:1 dev=sdc1 usb_scan_4=usb=3:1 dev=sdd1 usb_scan_list=1 2 3 4 usb_set_bootargs=setenv bootargs console=$console root=$usb_root rootdelay=$usb_ rootdelay rootfstype=$usb_rootfstype $mtdparts $usb_custom_params Environment size: 2590/131068 bytes DockStar>
Re: Semi-bricked Dockstar help needed: Have netconsole :( June 01, 2014 10:07AM |
Admin Registered: 13 years ago Posts: 18,858 |
** ext4fs_devread read error - blockAnd your u-boot env is set to Ext3
usb_rootfstype=ext3
setenv usb_rootfstype ext4
Re: Semi-bricked Dockstar help needed: Have netconsole :( June 01, 2014 11:00AM |
Registered: 10 years ago Posts: 3 |
> ** ext4fs_devread read error - block >> And your u-boot env is set to Ext3
> usb_rootfstype=ext3 >>
> setenv usb_rootfstype ext4 >>
Re: Semi-bricked Dockstar help needed: Have netconsole :( June 05, 2014 01:44PM |
Registered: 10 years ago Posts: 3 |