Re: Debian on Linksys EA4500 / EA4200 January 21, 2018 03:34AM |
Admin Registered: 13 years ago Posts: 19,114 |
Re: Debian on Linksys EA4500 / EA4200 January 21, 2018 08:50AM |
Registered: 7 years ago Posts: 67 |
Re: Debian on Linksys EA4500 / EA4200 September 17, 2018 03:47PM |
Registered: 11 years ago Posts: 87 |
mv643xx_eth_port mv643xx_eth_port.0 eth0: [0]: could not detect attached switch mv643xx_eth_port mv643xx_eth_port.0 eth0: [0]: couldn't create dsa switch instance (error -22)
Re: Debian on Linksys EA4500 / EA4200 September 17, 2018 04:16PM |
Registered: 11 years ago Posts: 87 |
Re: Debian on Linksys EA4500 / EA4200 September 17, 2018 06:02PM |
Admin Registered: 13 years ago Posts: 19,114 |
Re: Debian on Linksys EA4500 / EA4200 September 17, 2018 07:29PM |
Admin Registered: 13 years ago Posts: 19,114 |
> ip link set ethernet1 down >
Re: Debian on Linksys EA4500 / EA4200 September 17, 2018 08:23PM |
Admin Registered: 13 years ago Posts: 19,114 |
root@EA4500:/boot# lst uImage -rw-r--r-- 1 root root 4170563 Aug 26 02:31 uImage
root@EA4500:/boot# lst /boot/dts/kirkwood-ea4500.dtb -rw-r--r-- 1 root root 12419 Aug 25 12:11 /boot/dts/kirkwood-ea4500.dtb
root@EA4500:/boot# uname -a Linux EA4500 4.18.4-kirkwood-tld-1 #1 PREEMPT Fri Aug 24 22:13:40 PDT 2018 armv5tel GNU/Linux
root@EA4500:/boot# dmesg | grep eth | grep -v MAC [ 0.167998] [Firmware Info]: /ocp@f1000000/ethernet-controller@72000/ethernet0-port@0: local-mac-address is not set [ 7.751113] mv643xx_eth: MV-643xx 10/100/1000 ethernet driver version 1.4 [ 9.956473] mv88e6085 f1072004.mdio-bus-mii:10 ethernet1 (uninitialized): PHY [mv88e6xxx-0:00] driver [Generic PHY] [ 9.983657] mv88e6085 f1072004.mdio-bus-mii:10 ethernet2 (uninitialized): PHY [mv88e6xxx-0:01] driver [Generic PHY] [ 10.010351] mv88e6085 f1072004.mdio-bus-mii:10 ethernet3 (uninitialized): PHY [mv88e6xxx-0:02] driver [Generic PHY] [ 10.038254] mv88e6085 f1072004.mdio-bus-mii:10 ethernet4 (uninitialized): PHY [mv88e6xxx-0:03] driver [Generic PHY] [ 30.152072] mv643xx_eth: no PHY [ 30.152116] mv643xx_eth_port mv643xx_eth_port.0 eth0: link up, 1000 Mb/s, full duplex, flow control disabled [ 30.565558] mv88e6085 f1072004.mdio-bus-mii:10 ethernet1: configuring for phy/gmii link mode [ 30.584991] IPv6: ADDRCONF(NETDEV_UP): ethernet1: link is not ready [ 33.715505] mv88e6085 f1072004.mdio-bus-mii:10 ethernet1: Link is Up - 1Gbps/Full - flow control rx/tx [ 33.725006] IPv6: ADDRCONF(NETDEV_CHANGE): ethernet1: link becomes ready