[Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed June 17, 2011 01:12PM |
Registered: 13 years ago Posts: 136 |
Quote
Bus 001 Device 005: ID 0bda:8172 Realtek Semiconductor Corp. RTL8191S WLAN Adapter
Quote
[ 230.522346] usb 1-1: new high speed USB device using orion-ehci and address 2
[ 230.784280] r8712u: module is from the staging directory, the quality is unknown, you have been warned.
[ 230.812417] r8712u: DriverVersion: v7_0.20100831
[ 230.817107] r8712u: register rtl8712_netdev_ops to netdev_ops
[ 230.823546] r8712u: USB_SPEED_HIGH with 4 endpoints
[ 230.829131] r8712u: Boot from EFUSE: Autoload OK
[ 231.570761] r8712u: CustomerID = 0x0000
[ 231.574972] r8712u: MAC Address from efuse = 00:xx:xx:xx:xx:x5
[ 231.584432] usbcore: registered new interface driver r8712u
[ 299.122888] r8712u: 1 RCR=0x153f00e
[ 299.127127] r8712u: 2 RCR=0x553f00e
Quote
auto wlan0
iface wlan0 inet static
address 192.168.2.150
netmask 255.255.255.0
network 192.168.2.0
wpa-ssid "myssid"
wpa-psk "mywpapass"
Quote
wlan0 IEEE 802.11bg ESSID:"myssid" Nickname:"rtl_wifi"
Mode:Managed Frequency:2.437 GHz Access Point: 00:cc:cc:cc:cc:60
Bit Rate:54 Mb/s Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:****-****-****-****-****-****-****-**** Security mode:open
Power Management:off
Link Quality=100/100 Signal level=100/100 Noise level=0/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
pazos
Re: Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed June 17, 2011 01:55PM |
Re: Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed June 17, 2011 02:05PM |
Registered: 13 years ago Posts: 136 |
Quote
eth0 Link encap:Ethernet HWaddr 00:cc:cc:cc:cc:b0
inet addr:192.168.2.75 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::210:75ff:fe26:45b0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3333 errors:0 dropped:2 overruns:0 frame:0
TX packets:4575 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:5000
RX bytes:1325501 (1.2 MiB) TX bytes:997030 (973.6 KiB)
Interrupt:11
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:58 errors:0 dropped:0 overruns:0 frame:0
TX packets:58 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:6938 (6.7 KiB) TX bytes:6938 (6.7 KiB)
wlan0 Link encap:Ethernet HWaddr 00:cc:cc:cc:cc:55
inet addr:192.168.2.150 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::221:2fff:fe39:4a55/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3418 errors:0 dropped:156 overruns:0 frame:0
TX packets:63 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:816215 (797.0 KiB) TX bytes:4719 (4.6 KiB)
Quote
auto lo eth0
iface lo inet loopback
iface eth0 inet static
address 192.168.2.75
netmask 255.255.255.0
network 192.168.2.0
gateway 192.168.2.1
auto wlan0
iface wlan0 inet static
address 192.168.2.150
netmask 255.255.255.0
network 192.168.2.0
wpa-ssid "myssd"
wpa-psk "mywpapass"
Quote
nameserver 208.67.222.222
nameserver 8.8.8.8
nameserver 202.88.231.2
Quote
root@goflex:/home/varkey# ip route show
192.168.2.0/24 dev eth0 proto kernel scope link src 192.168.2.75
192.168.2.0/24 dev wlan0 proto kernel scope link src 192.168.2.150
default via 192.168.2.1 dev eth0
Re: Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed June 17, 2011 03:13PM |
Registered: 13 years ago Posts: 136 |
Quote
pazos
Maybe a static route makes 'ping' try to connect with eth0 interface and it doesn't work.
Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.2.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.2.0 0.0.0.0 255.255.255.0 U 0 0 0 wlan0 0.0.0.0 192.168.2.1 0.0.0.0 UG 0 0 0 wlan0 0.0.0.0 192.168.2.1 0.0.0.0 UG 0 0 0 eth0
auto wlan0 iface wlan0 inet static address 192.168.2.150 netmask 255.255.255.0 network 192.168.2.0 gateway 192.168.2.1 wpa-ssid "myssid" wpa-psk "mywpapass" post-up route del -net 192.168.2.0 netmask 255.255.255.0 dev eth0 pre-down route add -net 192.168.2.0 netmask 255.255.255.0 dev eth0
Re: Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed October 03, 2011 04:50PM |
Registered: 12 years ago Posts: 11 |
auto lo iface lo inet loopback auto eth0 iface eth0 inet static address 192.168.1.101 network 192.168.1.0 netmask 255.255.255.0 broadcast 192.168.1.255 gateway 192.168.1.1 dns-nameservers 192.168.1.1 auto wlan0 iface wlan0 inet static #wpa-driver ???? wpa-ssid calvin wpa-bssid [mymac] wpa-psk "[mypass]" wpa-key-mgmt WPA-PSK #wpa-pairwise TKIP CCMP #wpa-group TKIP CCMP #wpa-proto WPA RSN #wireless-essid calvin #wireless-mode master address 192.168.1.109 network 192.168.1.0 netmask 255.255.255.0 broadcast 192.168.1.255 gateway 192.168.1.1 dns-nameservers 192.168.1.1 post-up route del -net 192.168.1.0 netmask 255.255.255.0 dev eth0 pre-down route add -net 192.168.1.0 netmask 255.255.255.0 dev eth0
Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 * 255.255.255.0 U 0 0 0 wlan0 default WNDR3700v2 0.0.0.0 UG 0 0 0 wlan0 default WNDR3700v2 0.0.0.0 UG 0 0 0 eth0
Re: [Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed October 05, 2011 07:25AM |
Registered: 12 years ago Posts: 78 |
Re: [Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed October 06, 2011 06:26AM |
Registered: 12 years ago Posts: 11 |
auto lo iface lo inet loopback auto eth0 iface eth0 inet static address 192.168.1.101 netmask 255.255.255.0 gateway 192.168.1.1 auto wlan0 iface wlan0 inet static wpa-driver wext wpa-ssid calvin wpa-bssid [mymac] wpa-psk "[mypass]" wpa-key-mgmt WPA-PSK #wpa-pairwise TKIP CCMP #wpa-group TKIP CCMP #wpa-proto WPA RSN #wireless-essid calvin #wireless-mode master address 192.168.1.109 netmask 255.255.255.0 gateway 192.168.1.1 #post-up route del -net 192.168.1.0 netmask 255.255.255.0 dev eth0 #pre-down route add -net 192.168.1.0 netmask 255.255.255.0 dev eth0
Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 wlan0 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0 0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 wlan0
Re: [Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed October 07, 2011 07:29AM |
Registered: 12 years ago Posts: 78 |
Re: [Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed October 07, 2011 08:17AM |
Registered: 12 years ago Posts: 11 |
Re: [Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed October 08, 2011 09:15AM |
Registered: 12 years ago Posts: 78 |
Re: [Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed October 09, 2011 10:33AM |
Registered: 12 years ago Posts: 11 |
Re: [Solved] Realtek Wireless Dongle AWLL6075 - Stops working if ethernet cable is removed March 01, 2012 06:11PM |
Registered: 12 years ago Posts: 15 |