Forum List Message List New Topic
ingmar_k
Re: Howto: Install readonly emdebian on NAND
December 16, 2013 04:36PM
If the NSA325 has enough NAND Flash (>=128MB), then a Emdebian install in NAND should not be too difficult.
Reply Quote
kalehrl
Re: Howto: Install readonly emdebian on NAND
September 12, 2017 02:45PM
Does anyone know how to put the rootfs in internal flash of hp t5325?
I've managed to trim down the original rootfs to 300MB so it can fit the internal flash.
Reply Quote
bodhi
Re: Howto: Install readonly emdebian on NAND
September 12, 2017 05:52PM
kalehrl,

> Does anyone know how to put the rootfs in internal
> flash of hp t5325?
> I've managed to trim down the original rootfs to 3
> 00MB so it can fit the internal flash.

There is no need to do anything special for the T5325. The internal NAND flash for T5325 has SATA interface (it is sda1).

So you just mount the sda1 disk and tar the basic rootfs Debian-4.12.1-kirkwood-tld-1-rootfs-bodhi.tar.bz2 on it. Or tar your trimmed down rootfs on it. The same rule applies: label the sda1 partition rootfs. And unplug the USB drive. Boot as normal.

And please post follow up question in this T5325 Debian thread: https://forum.doozan.com/read.php?2,25473

-bodhi
===========================
Forum Wiki
bodhi's corner
Reply Quote
Page 5 of 5    Pages: Previous12345
Newer Topic Older Topic
Author:

Your Email:


Subject:
Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message: