USB Flash Drive not getting detected

Hello

I installed debian on a flashdrive yesterday but it failed to boot into debian. Later, once I was back to the pogoplug install, I connected the same flashdrive and checked the dmesg output and noticed that it goes in a cycle and is not working properly. I tried all 3 ports and the result is the same. Here is the dmesg log.

[  294.180000] usb-storage: device found at 4
[  294.180000] usb-storage: waiting for device to settle before scanning
[  304.760000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  319.840000] usb 1-1.2: device descriptor read/64, error -110
[  335.030000] usb 1-1.2: device descriptor read/64, error -110
[  335.220000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  350.300000] usb 1-1.2: device descriptor read/64, error -110
[  365.490000] usb 1-1.2: device descriptor read/64, error -110
[  365.680000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  376.100000] usb 1-1.2: device not accepting address 4, error -110
[  376.180000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  386.600000] usb 1-1.2: device not accepting address 4, error -110
[  386.600000] scsi 1:0:0:0: scsi: Device offlined - not ready after error recovery
[  386.610000] usb 1-1.2: USB disconnect, address 4
[  386.620000] usb-storage: device scan complete
[  386.700000] usb 1-1.2: new high speed USB device using ehci_marvell and address 5
[  401.780000] usb 1-1.2: device descriptor read/64, error -110
[  416.970000] usb 1-1.2: device descriptor read/64, error -110
[  417.160000] usb 1-1.2: new high speed USB device using ehci_marvell and address 6
[  432.240000] usb 1-1.2: device descriptor read/64, error -110
[  447.430000] usb 1-1.2: device descriptor read/64, error -110
[  447.620000] usb 1-1.2: new high speed USB device using ehci_marvell and address 7
[  458.040000] usb 1-1.2: device not accepting address 7, error -110
[  458.120000] usb 1-1.2: new high speed USB device using ehci_marvell and address 8
[  468.540000] usb 1-1.2: device not accepting address 8, error -110

How can I solve this? But the first time I tried the same drive, it worked fine. This is happening only after I finished the debian installation.



Edited 1 time(s). Last edit at 08/14/2010 02:50AM by varkey.

Try to use usbmount...

#apt-get install usbmount

Cheers,
Peter