USB Flash Drive not getting detected
August 14, 2010 02:49AM
Hello

I installed debian on a flashdrive yesterday but it failed to boot into debian. Later, once I was back to the pogoplug install, I connected the same flashdrive and checked the dmesg output and noticed that it goes in a cycle and is not working properly. I tried all 3 ports and the result is the same. Here is the dmesg log.

[  294.180000] usb-storage: device found at 4
[  294.180000] usb-storage: waiting for device to settle before scanning
[  304.760000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  319.840000] usb 1-1.2: device descriptor read/64, error -110
[  335.030000] usb 1-1.2: device descriptor read/64, error -110
[  335.220000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  350.300000] usb 1-1.2: device descriptor read/64, error -110
[  365.490000] usb 1-1.2: device descriptor read/64, error -110
[  365.680000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  376.100000] usb 1-1.2: device not accepting address 4, error -110
[  376.180000] usb 1-1.2: reset high speed USB device using ehci_marvell and address 4
[  386.600000] usb 1-1.2: device not accepting address 4, error -110
[  386.600000] scsi 1:0:0:0: scsi: Device offlined - not ready after error recovery
[  386.610000] usb 1-1.2: USB disconnect, address 4
[  386.620000] usb-storage: device scan complete
[  386.700000] usb 1-1.2: new high speed USB device using ehci_marvell and address 5
[  401.780000] usb 1-1.2: device descriptor read/64, error -110
[  416.970000] usb 1-1.2: device descriptor read/64, error -110
[  417.160000] usb 1-1.2: new high speed USB device using ehci_marvell and address 6
[  432.240000] usb 1-1.2: device descriptor read/64, error -110
[  447.430000] usb 1-1.2: device descriptor read/64, error -110
[  447.620000] usb 1-1.2: new high speed USB device using ehci_marvell and address 7
[  458.040000] usb 1-1.2: device not accepting address 7, error -110
[  458.120000] usb 1-1.2: new high speed USB device using ehci_marvell and address 8
[  468.540000] usb 1-1.2: device not accepting address 8, error -110

How can I solve this? But the first time I tried the same drive, it worked fine. This is happening only after I finished the debian installation.



Edited 1 time(s). Last edit at 08/14/2010 02:50AM by varkey.
Re: USB Flash Drive not getting detected
August 16, 2010 07:34AM
Try to use usbmount...

#apt-get install usbmount

Cheers,
Peter
Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message: