Welcome! Log In Create A New Profile

Advanced

Zyxel NSA325v2 brick

Posted by ehorher 
Re: Zyxel NSA325v2 brick
March 08, 2022 04:24PM
I believe that the installation was at least 4-5 years old.It was funplug-0.7
Unfortunately, I deleted the USB stick where was installed, but I found a copy of ffp root dir in my laptop with sub-dirs inside....this one for sure is older than the one on the USB...is too big to share here.....if help we have to find a way to transfer or put somewhere you can pick it up....
Re: Zyxel NSA325v2 brick
August 01, 2023 01:49AM
Hi everyone,

this may sound like a weird question, but since my NSA325v2 won't boot anymore (was running just fine until last night), I wanted to run the unbrick procedure.

But I can't figure out how to reboot the device at
Quote
piserver@piserver:~ $ kwboot -t -B 115200 /dev/ttyUSB1 -b u-boot.kwb -p
Sending boot message. Please reboot the target.../


Normally I would pull the VCC, but that leads to an error message
Quote

kwboot -t -B 115200 /dev/ttyUSB0 -b u-boot.kwb -p
Sending boot message. Please reboot the target.../
bootmsg: Input/output error

I think the UART adapter won't allow removing VCC and just plugging it back in.
Re: Zyxel NSA325v2 brick
August 01, 2023 05:32AM
AleXSR700,

> I think the UART adapter won't allow removing VCC
> and just plugging it back in.

Right! don't do that. This NSA325v2 box takes TXD, RXD, and GND. That's all you need.

Which serial converter are you using?

-bodhi
===========================
Forum Wiki
bodhi's corner (buy bodhi a beer)
Author:

Your Email:


Subject:


Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically. If the code is hard to read, then just try to guess it right. If you enter the wrong code, a new image is created and you get another chance to enter it right.
Message: