Hi fredk, This site explains how to activate the ssh service (dropbear) on a Pogoplug device without using the official Pogoplug Website. https://www.exploitee.rs/index.php/PogoPlug_Mobile#GPL Enjoy!by spooky2012 - Debian
Link is accessible! A glitch on my side... Sorry and and thank you again.by spooky2012 - Debian
@twinclouds - Thanks for the info but I'm sorry to inform you that the link is not accessible (to me ?) :-( Any mirror of that site? Thanks again for sharing.by spooky2012 - Debian
@superelchi So glad! Your firmware works perfectly! Backlight adjustment works fine. There is no reset button on this device. To enter bootloader mode and flash the new firmware: - had to unsolder the internal LiPo battery - plug USB cable while keeping power button pressed > sudo ./hiddetach Detaching dpf at 4-2:1.0... done. > sudo ./restore.py ../src/fw_winplus.binby spooky2012 - Displays
Hi Superelchi, I bought this pdf, named AC30604-60/6 from Winplus, display:2.4 TFT, 16MB, 320x240. http://www.amazon.com/Digital-Frame-Screen-Vent-Mount-Function/dp/B006G0CJW0 Here is the identify output: Detecting & reading dpf flash... Opening generic SCSI device '/dev/sg6' Manufacturer: Winbond Size : 4 MB Reading 400000 bytes from flash... Flash written tby spooky2012 - Displays
Hi bodhi, I followed your instructions to revert my Pogoplug Mobile to factory using the backup of the original firmware you've posted on this thread and it works! I've previously flashed davygravy's uboot and the uboot.environement so all I needed was to restore mtd0. After restoring, I rebooted the Pogo then replaced the values of "ethaddr" and "cesvcid&quby spooky2012 - uBoot
Here, one more Pogoplug Mobile successfully updated to your new 3.8.11 kernel! Can boot from mmc or usb, LEDs working (arcNumber=3960, machid=F78). Thanks for all your hard work and your precious time spent for all of us Bodhi!by spooky2012 - Debian