Show all posts by user
Discuss all things Debian on your device
Re: Zyxel NSA 325 - 2 years ago
Not sure why if you're trying to install OpenWrt you don't make use of the OpenWrt wiki page for the ZyXEL NSA325.by rayknight - uBoot
Re: Debian on Action Tech SG200 and MI424WR-rev-I - 2 years ago
bodhi, I'm reasonably certain that the Aruba AP-134 and AP-135 are using the internal switch on the 88F6560. There is a Marvell 88E1510M Phy on the board and with 2 Gigabit ports it is very likely that these devices are using 2 of the internal switch ports. It may be possible to obtain source code for this device by following instructions at https://www.arubanetworks.com/open_source/.by rayknight - Debian
Re: Debian on Action Tech SG200 and MI424WR-rev-I - 2 years ago
bodhi, Have you seen https://github.com/leitec/openwrt-staging/tree/avanta. In particular I believe some of the patches at https://github.com/leitec/openwrt-staging/tree/avanta/target/linux/avanta/patches-3.14 might be helpful. Rayby rayknight - Debian
Re: Lacie wireless space u-boot and jtag backup-restore with openocd - 2 years ago
According to LaCie-NAS Wiki the Wireless Space has mainline U-Boot support.by rayknight - uBoot
Re: Pogoplug V4 - no SATA or USB - 2 years ago
bodhi Wrote: ------------------------------------------------------- > netrunner, > > Cool! > > It happens often. Once during testing, I burnt a > 5V router box plugging in a 12V power supply :)) > Since that I labeled all my power supply cords at > the barrel connector. This is issue is what I consider an engineering failure! The Japan Electronics and Infoby rayknight - Debian
Re: Debian on Action Tech SG200 and MI424WR-rev-I - 2 years ago
Bodhi, Does it also automagically set the bootcmd? I find it extremely annoying when vendors try to lock down u-boot by setting very short bootdelay and forcing a particular bootcmd. Rayby rayknight - Debian
Re: BREED bootloader - Anyone here familiar with it? - 2 years ago
This is a proprietary boot loader without published source code. See the Copyright notice on the OpenWrt page you linked above.by rayknight - Off-Topic
Re: I done messed up! Lost uboot partition. - 2 years ago
@aaronouthier Was reading this thread and noticed that you are hoping to run OpenMediaVault on a Seagate GoFlexNet when you had determined that the Seagate GoFlexHome did not have enough memory to run it. Sorry to burst your bubble, but the GoFlexNet and GoFlexHome both have only 128MB RAM which is likely insufficient to run the resource heavy OpenMediaVault without heavy swapping activity!by rayknight - uBoot
Re: Doozan Debian on Checkpoint L-50 (W)? - 2 years ago
OpenWrt has patch files to add support for this device to u-boot (2020.04) and I believe the OpenWrt images actually make use of the updated u-boot. Rayby rayknight - Debian
Re: Debian on Action Tech SG200 - 2 years ago
The 88F6560 has a built in PHY if I recall correctly. On the MI424WR rev I and the Google GFRG110 the switch in the 88F6560 uses the Marvell 88E1545 PHY. The SG200 has only 1 Ethernet port, so uses the internal PHY. The Aruba AP-134 has 2 Ethernet ports and uses the 88E1540 PHY.by rayknight - Debian
Re: Debian on Action Tech SG200 - 2 years ago
As an FYI the Google Fiber Network Box (GFRG110) also uses the same SoC (88F6560). Source code is available at https://storage.googleapis.com/google-code-archive-source/v2/code.google.com/gfiber-gfrg100/source-archive.zip. I don't currently have any time to look at it, but would be interested in helping in the future, I have the mentioned Google Fiber Network Box, an Actiontec MI424WR Revby rayknight - Debian
Re: Debian cannot boot on KD20 after flashing u-boot - 2 years ago
Christiaan Wrote: > > I'm having a hard time disassembling the device > and the pictures that are referenced are not > available anymore since Google+ is down. > > Could you provide me with some pointers on how to > get the device open to connect to the serial > console? You must pry the white plastic right side of the device from the aluminum. I startedby rayknight - Debian
Re: Raspberry Pi 400 desktop - 2 years ago
I've seen pictures of the board inside the rPi 400 that clearly show a Bourns SM51625EL PoE++ Transformer on the board, but there is no mention of PoE support in anything documentation I have seen. Can't figure out why they would have a PoE Transformer but not advertise support for PoE! Rayby rayknight - Off-Topic
Re: Debian on Freecom Silverstore 2 NAS - 2 years ago
There is what is purported to be a u-boot for Silverstore NAS on github at https://github.com/TeXniKK/silverstore-uboot. It appears to be u-boot 1.1.4 based. You could build that and see if it will boot properly with kwboot. WikiDevi has the following statement about this device: Stock bootloader is locked to boot only Stock OS by checking signature. Rayby rayknight - Debian
Re: Pogo B03 Hangs on boot - VFS: Cannot open root device "(null)" or unknown-block(0,0): error -6 - 2 years ago
Please restart and stop the autoboot process by hitting a key. Then at the uboot prompt run 'printenv' and post the output. Rayby rayknight - Debian
Re: Pogo B03 Hangs on boot - VFS: Cannot open root device "(null)" or unknown-block(0,0): error -6 - 2 years ago
From a quick look it appears you forgot the step to label the USB ext3 partition as rootfs. On another Linux system insert the USB stick and run the following commands as root user (these assume your Linux system assigns sdc to the USB device): # e2label /dev/sdc1 rootfs # e2label /dev/sdc1 The second command should return the "rootfs" value. If so labeling was successful. Nowby rayknight - Debian
Re: HowTo: OpenWrt on Kirkwood boxes - 2 years ago
Can't recall the syntax off the top of my head, but you need to add a conditional statement to your bootcmd. Essentially you want to check if there is a bootable device in USB and if so boot from USB, otherwise boot from NAND. If you check the uboot environment that bodhi publishes there are examples of using conditional elements in his environment variables. See the uenv_read_disk for onby rayknight - Rescue System
Re: Possible to Install linux on MyCloud Home ? - 2 years ago
Realtek RTL SOC support has recently been added to the kernel. There are a few DTS files in arch/arm64/boot/dts/realtek. One is for a Synology NAS DiskStation DS418 so might be a good start if the SOC is the same. You did not post anything that indicates which of the various Realtek SOCs in the RTD series is being used here.by rayknight - uBoot
Re: NSA320 reboot-after-power-loss - 2 years ago
I have an NSA320 with stock firmware and backup as I'm working on an OpenWrt patch as the other Kirkwood ZyXel NAS devices are already supported. What exactly would you like to have from the original firmware? Rayby rayknight - Debian
Re: NSA310 - Is there a good 2020 step-by-step guide to follow? - 2 years ago
Christian, Take care that you determine exactly which NSA310 you have. There are at least 3 different NSA310 models each with their own DTB file (NSA310 - kirkwood-nsa310.dts, NSA310A - kirkwood-nsa310a.dts and NSA310S - kirkwood-nsa310s.dts). I have both the NSA310 and NSA310S models which already have serial port header installed. The NSA310 appears to be what is in your photo, the NSA31by rayknight - Debian
Re: Bricked Synology DS213 (Kirkwood) so close - 2 years ago
I believe there is support in the mainline Linux kernel for this device. See kirkwood-ds212.dts which supports the following Synology devices: model = "Synology DS212, DS212p v10, v20, DS213air v10, DS213 v10" There are also other kirkwood-ds*.dts files that support other Synology models. Rayby rayknight - uBoot
Re: Debian on Dell Kace M300 - 2 years ago
LeggoMyEggo Wrote: ------------------------------------------------------- > bodhi Wrote: > ------------------------------------------------------- > > I remember that mod and at one point was going to > implement it in all my plugs. Had the parts list > and everything. But as I am fickle, found new > plug devices to tinker with so the serial 3.5mm > mod went tby rayknight - Debian
Re: RN104 bricked - 2 years ago
bodhi Wrote: > UPDATE: > > Ping failed to connect to that site: > > PING update.readynas.com (206.16.42.180): 56 data > bytes > Request timeout for icmp_seq 0 > Request timeout for icmp_seq 1 > Request timeout for icmp_seq 2 > Request timeout for icmp_seq 3 > Request timeout for icmp_seq 4 > Request timeout for icmp_seq 5 > Request timeout forby rayknight - uBoot
Re: Android Smart TV Box 4GB as a Linux Desktop Computer - 2 years ago
That is an Allwinner H6 based device and you should be able to modify the Armbian support for the Pine-H64 to boot on this box. Rayby rayknight - Off-Topic
Re: RN10400 - 2 years ago
AkkJaa, There is extensive documentation regarding this device at http://natisbad.org/NAS3/index.html. This includes information regarding serial access. The RN102 is similar and his page for that device gives a better visual of connecting the serial dongle. Rayby rayknight - uBoot
Re: Linux Kernel 5.8.5 MVEBU package and Debian armhf rootfs - 2 years ago
Bodhi, Can you explain what it is that requires a separate kernel for the Netgear RN102 and GTI Mirabox? I thought that using DTS was supposed to cover the differences for hardware using the same architecture/SOC. Rayby rayknight - Debian
Re: NSA310 original u-boot request - 2 years ago
If you still require stock u-boot for the NSA310 I have attached a compressed tar file containing mtd0.img and mtd1.img from a recently acquired NSA310 with 1.2 GHz Marvell 88F6281 processor and the Realtek Ethernet. I have successfully tested restoring from the mtd0.img after using uboot.2017.07-tld-1.nsa310.mtd0.kwb Rayby rayknight - uBoot
Re: POGO-V4-A3-01 + 2017.07 U-Boot Kirkwood + Debian 5.2.9 rootfs - 3 years ago
For your locale issue have you tried running the below command? dpkg-reconfigure localesby rayknight - Debian
Re: NSA310 original u-boot request - 3 years ago
This is enough information for me to determine that you have a different version of the NSA310 than I. Mine is a NSA310S which has the 88F6702 processor and Marvell Ethernet, so my u-boot backup likely won't be helpful. Rayby rayknight - uBoot
Re: Any USB 3-bootable SOCs look good to anyone lately? - 3 years ago
See https://smile.amazon.com/gp/product/B081NDDTHC/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1 for an example of a Baseboard that takes one of these modules. There are many others. Rayby rayknight - Off-Topic