I actually did successfully rebooted using a minimum set of setenv. I had troubles with quoting and $(var) being replaced by ${var}. But it now boots alone again !by treepleks - uBoot
Hello bohdi, I just received my USB/UART TTL converter. I connected to the serial port inside the iConnect and... the serial connection is working. I effectively noticed that the env variables are absent. Upon booting, u Boot says U-Boot 2014.01-tld-1 (Mar 17 2014 - 22:10:57) Iomega iConnect od 88F6281_A0 DRAM: 256 MiB WARNING: Caches not enabled NAND: 512 MiB *** Warning - bad Cby treepleks - uBoot
Ok. I will need cables then... I'm going to order some. Thanks for your help proposal. I'll come back soon :-) Treepleksby treepleks - uBoot
I just realized the arcnumber is still arcNumber=1682 could it be the source of the problem ?by treepleks - uBoot
I got an i-Connect and wanted to setup a small NAS/Audio server on it. I successfully installed ArchLinux, booting from an USB disk, following http://archlinuxarm.org/forum/viewtopic.php?t=1472. This is a simple move: it just changes the bootcmd to scan usb port first and boot from /boot/uImage if it can be found. Everything worked fine, but an ArchLinux update broke the system. Apparently,by treepleks - uBoot