I figured out what my issue was. Somehow the uboot-original-mtd0.kwb file that is stored in the root of mtdblock2 was not there. I downloaded one off the web and put it in the root of mtdblock2 and it fixed my issue, I can now boot off pogo os or usb thumbdrive. Thanks Keithby keith - uBoot
@bodhi, I did enter both commands and tried various attempts. Seems to be non interactive. Keithby keith - uBoot
Tried nc with scientific linux and also doesnt allow me to interrupt the bootby keith - uBoot
I tried to interact with the console when running nc but for some reason it didnt respond. I am running Linux Mint and installed the nc.traditional package. Will load up another os and try.by keith - uBoot
I have rerun the install with no change in results. output below # ./install_uboot_mtd0.sh !!!!!! DANGER DANGER DANGER DANGER DANGER DANGER !!!!!! If you lose power to your device while running this script, it could be left in an unusable state. This script will replace the bootloader on /dev/mtd0. This installer will only work on the following devices: Seagate Dockstar Seby keith - uBoot
Thanks for responding. I have attached the output from fw_printenv as well as the console output with my archlinuxarm usb stick in and without the usb stick. fw_printenv ethact=egiga0 bootdelay=3 baudrate=115200 mainlineLinux=yes console=ttyS0,115200 led_init=green blinking led_exit=green off led_error=orange blinking mtdparts=mtdparts=orion_nand:1M(u-boot),4M(uImage),32M(rootfs),-(by keith - uBoot
Hey there, looking for a little help with a E02. I currently am running ALARM on it. When I remove the usb key and try to reboot the pogo os, it never boots, no led on the front. I put the isb stick back in, reboot, ALARM comes up. Would like to figure out what I did. Keithby keith - uBoot