This should ideally be posted on the PlugComputer forums, but I can't get myself registered there, so posting here in the hope that I will be forgiven :). I use Debian on a GoFlex Home. The device is being used in a production environment and running 24/7. I notice that the system seems to heat up quite a bit (though there is no SATA drive plugged in); it is however cooler than the SheevaPlug, which runs like an oven.
I would like to monitor temperature to discover if it's running at dangerous levels. However I can't get a clear idea of whether the GoFlex has temperature sensors on its board at all. In Debian, neither /sys nor /proc has any thermal zone folders. Does the GoFlex have a temperature sensor? If so, how might I access it from a Debian system?
Alternatively, has anyone seen their GoFlex suffer thermal damage?