blparam errors followed by Unknown uBoot detected on mtd0

Here's what's happening on my Dockstar (it's my first time trying to mod an embedded device and my Linux knowledge is weak). The first time I tried the install the prompt was bash: - after a reboot the prompt changed to PogoPlug: - not sure if this matters or not. Please tell me how to get past these error and get it installed. I'm hesitant on using the no uboot check parameter since I don't think I've installed anything yet. Thanks!


Would you like to disable the pogoplug services? [Y/n] y
Applying fixes to the pogoplug environment...
Disabling the pogoplug service...
Done fixing pogoplug environment.

# checking for /uboot-original-mtd0.kwb...
# checking for /usr/sbin/blparam...
# checking for /usr/sbin/nandwrite...
# checking for /usr/sbin/nanddump...
# checking for /usr/sbin/flash_erase...
# checking for /usr/sbin/fw_printenv...
# checking for /etc/fw_env.config...

# Attempting to auto-detect your device..../install_uboot_mtd0.sh: line 285: /usr/sbin/blparam: Permission denied
./install_uboot_mtd0.sh: line 286: /usr/sbin/blparam: Permission denied
failed!

############################################
Your device could not be auto-detected.

You must be using a Seagate Dockstar or Pogoplug Pink to run this installer.

What device are you using? Type the number of your device and press ENTER.
1 - DockStar
2 - Pogoplug v2 - Pink
3 - Other
1
Selected Dockstar

# Checking for existing uBoot on mtd0...
Connecting to jeff.doozan.com (69.163.187.226:80)
uboot.mtd0.kwb.md5 100% |******************************************| 49 --:--:-- ETA
Block size 131072, page size 2048, OOB size 64
Dumping data starting at 0x00000000 and ending at 0x00080000...
Connecting to jeff.doozan.com (69.163.187.226:80)
valid-uboot.md5 100% |******************************************| 404 --:--:-- ETA
## Unknown uBoot detected on mtd0: b2d9681ef044e9ab6b058ef442b30b6e
##
## The installer could not detect the version of your current uBoot
## This may happen if you have installed a different uBoot on
## /dev/mtd0 or if you have bad blocks on /dev/mtd0
##
## If you have bad blocks on mtd0, you should not try to install uBoot.
##
## If you have installed a diffirent uBoot on mtd0, and understand the
## risks, you can re-run the installer with the --no-uboot-check parameter
##
## Installation cancelled.
Pogoplug:/tmp$

I've updated the installer to fix this.

-- Jeff

Thanks Jeff. I removed the installer by running
rm install_uboot_mtd0.sh

...then I followed these instructions again
cd /tmp
wget http://plugapps.com/os/pogoplug/uboot/install_uboot_mtd0.sh
chmod +x install_uboot_mtd0.sh
./install_uboot_mtd0.sh

...and I received the exact same errors as I pasted previous output. I'm just back to the Pogoplug: prompt. Could you please tell me any other options I can try?

Thanks!

i am getting this error on a brand new pogoplug - any ideas?

my putty prompt nows says Pogoplug:~S rather than Bash# too