Pogoplug v2 Uboot woes July 16, 2014 10:01PM |
Registered: 9 years ago Posts: 3 |
U-Boot 2014.04.R3-1 (May 26 2014 - 19:45:55) Arch Linux ARM Pogo E02 SoC: Kirkwood 88F6281_A0 DRAM: 256 MiB WARNING: Caches not enabled NAND: 128 MiB In: serial Out: serial Err: serial Net: egiga0 Hit any key to stop autoboot: 0 (Re)start USB... USB0: USB EHCI 1.00 scanning bus 0 for devices... 3 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found ** File not found /rescueme ** ** Unrecognized filesystem type ** UBI: attaching mtd1 to ubi0 UBI: physical eraseblock size: 131072 bytes (128 KiB) UBI: logical eraseblock size: 129024 bytes UBI: smallest flash I/O unit: 2048 UBI: sub-page size: 512 UBI: VID header offset: 512 (aligned 512) UBI: data offset: 2048 UBI: attached mtd1 to ubi0 UBI: MTD device name: "mtd=3" UBI: MTD device size: 91 MiB UBI: number of good PEBs: 727 UBI: number of bad PEBs: 1 UBI: max. allowed volumes: 128 UBI: wear-leveling threshold: 4096 UBI: number of internal volumes: 1 UBI: number of user volumes: 0 UBI: available PEBs: 716 UBI: total number of reserved PEBs: 11 UBI: number of PEBs reserved for bad PEB handling: 7 UBI: max/mean erase counter: 1/1 UBIFS error (pid 0): ubifs_get_sb: cannot open "rootfs", error -22 UBIFS error (pid 0): ubifs_mount: Error reading superblock on volume 'rootfs' errno=-22! ubifsmount - mount UBIFS volume Usage: ubifsmount <volume-name> - mount 'volume-name' volume 1 bytes read in 112 ms (0 Bytes/s) Found bootable drive on usb 0:1 EHCI timed out on TD - token=0xa0008d80 EHCI timed out on TD - token=0x20008d80 EHCI timed out on TD - token=0x20008d80 ** ext4fs_devread read error - block ** File not found /boot/uInitrd ** ## Booting kernel from Legacy Image at 00800000 ... Image Name: Linux-3.14.4-1-ARCH Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3965072 Bytes = 3.8 MiB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... Bad Data CRC ERROR: can't get kernel image! stopping USB.. Unknown command 'fsload' - try 'help' Unknown command 'fsload' - try 'help' resetting ...and then it does that on a loop.
SoC: Kirkwood 88F6281_A0 DRAM: 256 MiB WARNING: Caches not enabled NAND: 128 MiB In: serial Out: serial Err: serial Net: egiga0 Hit any key to stop autoboot: 0 (Re)start USB... USB0: USB EHCI 1.00 scanning bus 0 for devices... 2 USB Device(s) found scanning usb for storage devices... 0 Storage Device(s) found ** Bad device usb 0 ** ** Bad device usb 0 ** UBI: attaching mtd1 to ubi0 UBI: physical eraseblock size: 131072 bytes (128 KiB) UBI: logical eraseblock size: 129024 bytes UBI: smallest flash I/O unit: 2048 UBI: sub-page size: 512 UBI: VID header offset: 512 (aligned 512) UBI: data offset: 2048 UBI: attached mtd1 to ubi0 UBI: MTD device name: "mtd=3" UBI: MTD device size: 91 MiB UBI: number of good PEBs: 727 UBI: number of bad PEBs: 1 UBI: max. allowed volumes: 128 UBI: wear-leveling threshold: 4096 UBI: number of internal volumes: 1 UBI: number of user volumes: 0 UBI: available PEBs: 716 UBI: total number of reserved PEBs: 11 UBI: number of PEBs reserved for bad PEB handling: 7 UBI: max/mean erase counter: 1/1 UBIFS error (pid 0): ubifs_get_sb: cannot open "rootfs", error -22 UBIFS error (pid 0): ubifs_mount: Error reading superblock on volume 'rootfs' errno=-22! ubifsmount - mount UBIFS volume Usage: ubifsmount <volume-name> - mount 'volume-name' volume ** Bad device usb 0 ** ** Bad device usb 1 ** ** Bad device usb 2 ** ** Bad device usb 3 ** ** Bad device usb 0 ** ** Bad device usb 0 ** Wrong Image Format for bootm command ERROR: can't get kernel image! stopping USB.. Unknown command 'fsload' - try 'help' Unknown command 'fsload' - try 'help' resetting ...
PogoE02> printenv arcNumber=3542 baudrate=115200 bootargs=$(console) $(bootargs_root) bootargs_root=root=/dev/mtdblock2 ro bootcmd=usb start; run force_rescue_bootcmd; run ubifs_bootcmd; run usb_bootcmd; usb stop; run rescue_bootcmd; run pogo_bootcmd; reset bootdelay=3 bootm=echo Booting from ${disk} ...; run setargs; bootm ${loadaddr}; bootz=echo Booting from ${disk} ...; run setargs; bootz ${loadaddr} - ${fdt_addr}; console=ttyS0,115200 ethact=egiga0 ethaddr=00:25:31:00:95:6A fdt_addr=0x800000 fdt_file=/boot/dtbs/kirkwood-pogo_e02.dtb force_rescue=0 force_rescue_bootcmd=if test $force_rescue -eq 1 || ext2load usb 0:1 0x1700000 /rescueme 1 || fatload usb 0:1 0x1700000 /rescueme.txt 1; then run rescue_bootcmd; fi importbootenv=echo Importing environment (uEnv.txt)...; env import -t $loadaddr $filesize ipaddr=192.168.1.99 led_error=orange blinking led_exit=green off led_init=green blinking load=echo Attempting to boot from ${type} ${disk}:1...;if run loadbootenv; then run importbootenv;fi;echo Checking if uenvcmd is set ...;if test -n $uenvcmd; then echo Running uenvcmd ...;run uenvcmd;fi;echo Running default loadzimage ...;if run loadzimage; then run loadfdt;run bootz;fi;echo Running default loaduimage ...;if run loaduimage; then run bootm;fi; loadaddr=0x810000 loadbootenv=load ${type} ${disk}:1 ${loadaddr} /boot/uEnv.txt loadfdt=load ${type} ${disk}:1 ${fdt_addr} ${fdt_file} loaduimage=load ${type} ${disk}:1 ${loadaddr} ${uimage} loadzimage=load ${type} ${disk}:1 ${loadaddr} ${zimage} mainlineLinux=yes mtdids=nand0=orion_nand mtdparts=mtdparts=orion_nand:1M(u-boot),4M(uImage),32M(rootfs),-(data) partition=nand0,2 pogo_bootcmd=if fsload uboot-original-mtd0.kwb; then go 0x800200; fi rescue_bootcmd=if test $rescue_installed -eq 1; then run rescue_set_bootargs; nand read.e 0x800000 0x100000 0x400000; bootm 0x800000; else run pogo_bootcmd; fi rescue_installed=0 rescue_set_bootargs=setenv bootargs console=$console ubi.mtd=2 root=ubi0:rootfs ro rootfstype=ubifs $mtdparts $rescue_custom_params serverip=192.168.1.89 setargs=setenv bootargs console=${console},${baudrate} ${optargs} root=/dev/sd${letter}1 rw rootwait ${mtdparts} stderr=serial stdin=serial stdout=serial ubifs_bootcmd=run ubifs_set_bootargs; if ubi part data && ubifsmount rootfs && ubifsload 0x800000 /boot/uImage && ubifsload 0x1100000 /boot/uInitrd; then bootm 0x800000 0x1100000; fi ubifs_mtd=3 ubifs_set_bootargs=setenv bootargs console=$console ubi.mtd=$ubifs_mtd root=ubi0:rootfs rootfstype=ubifs $mtdparts $ubifs_custom_params uimage=/boot/uImage usb_boot=mw 0x800000 0 1; ext2load usb $usb_device 0x800000 /boot/uImage; if ext2load usb $usb_device 0x1100000 /boot/uInitrd; then bootm 0x800000 0x1100000; else bootm 0x800000; fi usb_bootcmd=run usb_init; run usb_set_bootargs; run usb_boot usb_device=0:1 usb_init=run usb_scan usb_root=/dev/sda1 usb_rootdelay=10 usb_rootfstype=ext3 usb_scan=usb_scan_done=0;for scan in $usb_scan_list; do run usb_scan_$scan; if test $usb_scan_done -eq 0 && ext2load usb $usb 0x800000 /boot/uImage 1; then usb_scan_done=1; echo "Found bootable drive on usb $usb"; setenv usb_device $usb; setenv usb_root /dev/$dev; fi; done usb_scan_1=usb=0:1 dev=sda1 usb_scan_2=usb=1:1 dev=sdb1 usb_scan_3=usb=2:1 dev=sdc1 usb_scan_4=usb=3:1 dev=sdd1 usb_scan_list=1 2 3 4 usb_set_bootargs=setenv bootargs console=$console root=$usb_root rootdelay=$usb_rootdelay rootfstype=$usb_rootfstype $mtdparts $usb_custom_params zimage=/boot/zImage Environment size: 3558/131068 bytes
Re: Pogoplug v2 Uboot woes July 17, 2014 09:18AM |
Admin Registered: 13 years ago Posts: 18,650 |
Re: Pogoplug v2 Uboot woes July 17, 2014 05:40PM |
Registered: 9 years ago Posts: 3 |
johnny@alarm ~ $ fsck /dev/sdb1 fsck from util-linux 2.20.1 e2fsck 1.42.5 (29-Jul-2012) fsck.ext2: Permission denied while trying to open /dev/sdb1 You must have r/w access to the filesystem or be root johnny@alarm ~ $ sudo !! sudo fsck /dev/sdb1 fsck from util-linux 2.20.1 e2fsck 1.42.5 (29-Jul-2012) /dev/sdb1: clean, 27854/247008 files, 142805/986179 blocks johnny@alarm ~ $ sudo fsck /dev/sdb1 -f fsck from util-linux 2.20.1 e2fsck 1.42.5 (29-Jul-2012) Pass 1: Checking inodes, blocks, and sizes Pass 2: Checking directory structure Pass 3: Checking directory connectivity Pass 4: Checking reference counts Pass 5: Checking group summary information /dev/sdb1: 27854/247008 files (4.7% non-contiguous), 142805/986179 blocks
Re: Pogoplug v2 Uboot woes July 17, 2014 06:05PM |
Admin Registered: 13 years ago Posts: 18,650 |
** ext4fs_devread read error - block ** File not found /boot/uInitrd ** ## Booting kernel from Legacy Image at 00800000 ... Image Name: Linux-3.14.4-1-ARCH Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3965072 Bytes = 3.8 MiB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... Bad Data CRC
Re: Pogoplug v2 Uboot woes July 17, 2014 09:06PM |
Registered: 9 years ago Posts: 3 |
sudo sfdisk -l /dev/sdb Disk /dev/sdb: 1018 cylinders, 125 heads, 62 sectors/track Units = cylinders of 3968000 bytes, blocks of 1024 bytes, counting from 0 Device Boot Start End #cyls #blocks Id System /dev/sdb1 0+ 1017 1018- 3944719 7 HPFS/NTFS/exFAT /dev/sdb2 0 - 0 0 0 Empty /dev/sdb3 0 - 0 0 0 Empty /dev/sdb4 0 - 0 0 0 Empty
Re: Pogoplug v2 Uboot woes July 18, 2014 01:03AM |
Admin Registered: 13 years ago Posts: 18,650 |
Device Boot Start End Blocks Id System /dev/sda1 * 2048 976773166 488385559+ 83 Linux