Please help with unbrick iomega ix2-200.

When trying to install Debian, it cleared the NAND.

I installed JTAG and connected to ix-200 using OpenOCD (using configuration files from iomega iconnect)


It turned out according to the instructions for installing openWRT on iconnect loaded in RAM uboot from iomega iconnect (uboot.kwb to the address 0x0600000, start from 0x0600000, then on the serial port I see a response from the NAS, there I tried to load an different backup\image to the address 0x0, but the NAS still does not load after resetting.

how do I restore the NAS? Thanks

alexma,

In the Wiki thread:

https://forum.doozan.com/read.php?2,23630

Quote

Serial Console & JTAG console

Repair Pogo E02 with Raspberry PI (JTAG) and OpenOCD

This iomega ix2-200 box is a Kirkwood SoC box, so the steps should be followed exactly the same. Except that you can use the iConnect uboot image, or one for the ix2-200.

Somewhere in this forum there was a post that has the mtd0 backup for this ix2-200 box, IIRC. Unfortunately I did not save that link.

-bodhi
===========================
Forum Wiki
bodhi's corner (buy bodhi a beer)